Hawking Technology HNC290G manual Maintenance

Maintenance

Load Default	To reset the camera to its factory default settings, click “Apply”. Then,
	follow the instructions on the screen to complete the process. The
	factory default settings are as follows.
	Camera Name: “HNC290G”
	IP Address: “192.168.2.3”
	Subnet Mask: 255.255.255.0
	Administrator Name: “Admin”; Password: “1234”
	Video Port: “5000”; Web Port: “80”
Reboot System	To reboot the camera, click “Reboot System” and then click “Apply”.
LED Light OFF/ON	There are four LEDs to indicate the status of camera. If you want to
	prevent the camera from being noticed, you can turn off the LED lights
	by clicking “LED Light OFF” and then clicking “Apply”. To turn on
	the LED lights, click “LED Light ON” and then click “Apply”.
Upgrade Firmware	Clicking the “Upgrade Firmware” and “Apply” buttons will lead you to
	the upgrade page. Select the “*.bin” file and click “Upgrade” to begin
	upgrading. Note that the camera will stay in upgrade mode until you
	finish upgrading the firmware.

61