Digimerge DHU104 instruction manual Alarm Input, Alarm Output

Event / Sensor

ALARM INPUT

Configurations for any external alarm device (i.e. a Door or Window Sensor). Refer to the appendices for hardware configuration details.

•Operation - Sets the Alarm Sensor Connection Status (Enable / Disable) for an external alarm (i.e. Door or Window Sensors).

•Type: Sets the Alarm Sensor type to N/O (Normally Open) or N/C (Normally Closed).

•N/O (Normally Open) - Select for an Alarm that has a Normally Open circuit (such as a door that remains open). An Alarm will occur when this is changed to a Closed status.

•N/C (Normally Closed) - Select for an Alarm that has a Normally Closed circuit (such as a Window Sensor). An Alarm will occur when this is changed to a Opened status.

ALARM OUTPUT

Sends an Alarm Out signal to a device (such as a Manual Door or independent Light/Buzzer Alarm) when an Alarm In event is detected.

Note: You must have the option, “Operation,” ENABLED in order to configure the options in this menu.

•Relay - By default, 1. Non-selectable.

•Mode - Setup Reacted Relay as either Latched or Transparent Mode:

•Latched – When sensor alarm activated, relay reacted in setup duration.

•Transparent – Relay reacted temporary during sensor alarm activate.

•Type - Set the Relay Type to either N/ O (Normally Open) or N/C (Normally Closed).

•Operation - Setup Relay Connect with Alarm Sensor to either Enable or Disable.

34