JVC VN-C655 manual Check settings, Start up the V.Networks Controller

2.Check settings.

1 Select whether to use DHCP.

Note

The IP address of the DHCP server and other information can be checked when [DHCP] is selected.

2 Change the IP address to the one assigned to or approved by the administrator.

3 Set Subnet mask to an appropriate value. Ask the network administrator if necessary.

4 Click .

For other settings, ☞ next page

3.Click .

[V.Networks ID] works as an identification code set to VN-C655. Only alphanumeric characters can be used.

This ID does not directly affect operation by the user.

Normally, the ID is set as CAM00001, CAM00002, etc.

(0 to 8 characters)

Click .

4.Start up the "V.Networks Controller". (☞ Page 54)

Note

Note

Upon clicking OK, VN-C655 will be automatically reset and the set values will be enabled.

In a system where more than 1 VN-C655 is used, turn on the power for a VN-C655 first, followed by setting the camera until "2-3 Setting IP Address for this Camera Using the 'VN-C655U Setup Tool' " is completed. Upon doing so, turn on a second camera and perform setting in the same way. Perform the same procedure for subsequent cameras.

29