JVC TK-C676 Cover, Camera Connector Female, @ Drop Prevention Hook, # Clamping Holes x, Lens

# % $

! #

@

(Setting switch side)

0Cover

For protection against water drips. Slit the rubber cap on

this cover and pass the cable through the slits. ☞ P. 14

!Camera Connector (Female)

Connect to ^, the Male Connector on the camera.

@Drop Prevention Hook

Attach the Drop Prevention Wire & to this hook to prevent the camera from falling.

#Clamping Holes (x 4)

Attach the camera to a ceiling or to a Ceiling Flush Mount Bracket (optionally available) using these holes.

$[MACHINE ID] Switch

When an RS-485 communication system is used, for ex- ample when using the camera in a system controlled by an RM-P2580, set the camera IDs individually for each

camera. ☞ P. 13

%Setting Switches

Use these to set the PROTOCOL, etc. ☞ P. 12

	&	ENGLISH
^

*

⁄

)(

^Connector (Male)

Connect to !, the Female Camera Connector on the Ceil- ing Mount.

&Drop Prevention Wire

Attach this wire to the Drop Prevention Hook @ on the Ceiling Mount.

*Camera Clamping Bracket

In order to clamp the camera onto the Ceiling Mount, in- sert and tighten the Locking Screw 4 into this bracket.

(Lens

The lens cannot be replaced.

)Dome Cover

The dome cover is fragile. Take care when handling it.

⁄Camera Body Cover

Do not remove the camera body cover while the camera is installed on a ceiling. Doing so will cause the dome cover to fall down.

E-7