JVC GR-DVP10 manual 42 EN, Motor Drive Mode, To end Self-Timer recording, select OFF in step

42 EN FEATURES FOR RECORDING (cont.)

●If Program AE with special effects ( pg. 33) is engaged, certain modes of Program AE with special effects are disabled during Snapshot recording. In such a case, the icon blinks.

●If SNAPSHOT is pressed when “DIS” is set to

“ON” ( pg. 36), the Stabiliser will be disabled.

●During playback as well, all snapshot modes except Nega mode are available when

“ COPY” is set to “OFF” in VIDEO Menu. ( pg. 40) However, the shutter sound is not heard.

●During Snapshot recording, the image displayed in the viewfinder may be partially missing. However, there is no effect in the recorded image.

●When the S/AV/Editing cable is connected to the S/AV connector, the shutter sound is not heard from the speaker, however it is recorded onto the tape.

Motor Drive Mode

Keeping SNAPSHOT pressed in step 5 provides an effect similar to serial photography. (Interval between still images: approx. 1 second)

●The Motor Drive mode is disabled when “REC

SELECT” is set to “ / ”. ( pg. 39)

Self-Timer

Once the camcorder is set, the camcorder operator can become part of the scene in a more natural way, adding the final touch to a memorable picture.

1Set the Power Switch to “M” while pressing down the Lock Button located on the switch.

2Open the LCD monitor fully, or pull out the viewfinder fully.

●You can tilt the LCD monitor upward to 180° so that it faces forward and view yourself while self-recording with the viewfinder pushed back.

5To stop Self-Timer recording, press the Recording Start/Stop Button again.

●The camcorder re-enters Record-Standby mode.

OR

5Press SNAPSHOT.

●After 15 seconds, the beep sounds and snapshot recording starts. After that, the camcorder re-enters Record-Standby mode.

6To end Self-Timer recording, select “OFF” in step 3.

NOTE:

If “BEEP” and “TALLY” are set to “OFF” ( pg. 37), the beep does not sound and the tally lamp does not light.

When the Recording Start/Stop Button or SNAPSHOT is pressed, the tally lamp changes as shown:

Begins blinking (Self-Timer starts)

Blinks quickly (Self-Timer shooting starts soon)

Stops blinking and stays on After approx.

3Set “SELF-TIMER” to

“ON ”. ( pg. 31, 36)

4To engage the Self-Timer for video recording, press the Recording Start/Stop Button.

●After 15 seconds, the beep sounds and video recording starts.

MANUAL

SEL F – T I MER – OF F ON

RETURN

(Self-Timer video recording starts)

OR

Turns off (Self-Timer snapshot recording occurs)

15 sec.

Self-Timer indication