EN 43
Auto Focus
The camcorder’s Full Range AF system offers continuous shooting ability from
Focus detection zone
However, correct focus may not be obtainable in the situations listed below (in these cases perform “Manual Focus”):
●When two subjects overlap in the same scene.
●When illumination is low.*
●When the subject has no contrast (difference in brightness and darkness), such as a flat, one- colour wall, or a clear, blue sky.*
●When a dark object is barely visible in the LCD monitor or the viewfinder.*
●When the scene contains minute patterns or identical patterns that are regularly repeated.
●When the scene is affected by sunbeams or light reflecting off the surface of a body of water.
●When shooting a scene with a
*The following 
, 
, 
and 
NOTES:
●If the lens is smeared or blurred, accurate focusing is not possible. Keep the lens clean. ( pg. 73) When condensation occurs, wipe with a soft cloth or wait for it to dry naturally.
●When shooting a subject close to the lens, zoom out first. ( pg. 18) If
Manual Focus
NOTE:
If you are using the viewfinder, you should already have performed “Viewfinder Adjustment”
( pg. 12).
1Set the Power Switch to “M” while pressing down the Lock Button located on the switch.
2Press FOCUS. The manual focus indicator appears.
3To focus on a further subject, press +. The “ 
” indicator appears and blinks.
While focusing on a further subject
Manual focus indicator
To focus on a nearer subject, press 
” indicator appears and blinks.
While focusing on a nearer subject
Manual focus indicator
4Press SET/SELECT. Focus adjustment is complete.
●To reset to Auto Focus, press FOCUS twice or set the Power Switch to “A”.
●If FOCUS is pressed once, the camcorder will enter the focus adjustment mode again.
NOTES:
●Be sure to focus the lens in the maximum telephoto position when you use the Manual Focus mode. If you focus in on a subject in the
●When the focus level cannot be adjusted any further or closer, “ 
” or “
” will blink.
ADVANCED FEATURES