JVC GR-DVP10 manual Dubbing Still Images Recorded On

				EN 53
Dubbing Still Images Recorded On		1	Load a cassette. ( pg. 15)
		2	Load a memory card. ( pg. 16)
A Tape To A Memory Card		3	Set the VIDEO/MEMORY Switch to “VIDEO”.
Still images can be dubbed from a tape to a memory		4	Set the Power Switch to “P” while pressing
			down the Lock Button located on the switch.
card.		5 Set “		COPY” to “ON”. ( pg. 31, 40)
VIDEO/MEMORY Switch
		6	Press 4/9 to start playback.
		7	At the point you want to dub, press 4/9 again to
		8	engage Still Playback.
			To dub the image, press SNAPSHOT.
	Play/Pause Button		● The ”	” indication appears during
			dubbing.
	(4/9)		● The selected image is stored in the memory
	Power Switch		card.
		NOTES:
		● If SNAPSHOT is pressed in step 8 when a memory
		card is not loaded, the message “COPYING
		FAILED” is displayed.
SNAPSHOT		● If an image recorded on the tape using “WIDE
	Lock Button	MODE” ( pg. 37) is dubbed to a memory card,
Button
		the WIDE mode identifying signal is not dubbed
		with it.
SET/SELECT	MENU Button	● To use Playback Special effects with a video image
		you wish to dub, perform up to step 8 using the
Button	+, – Button	remote control (provided). ( pg. 55)
		● Images are dubbed in 640 x 480 pixels.

ADVANCED FEATURES