JVC GR-D790U manual Language Settings, Data Battery System, Maximum continuous recording time

14 EN GETTING STARTED

Using The Battery Pack							● If “COMMUNICATION ERROR” appears
								instead of the battery status even though you
Perform steps 2 – 3 in “Charging The Battery
								tried to press DATA several times, there may
Pack” ( pg. 13).								be a problem with your battery. In such a
Maximum continuous recording time								case, consult your nearest JVC dealer.
							Using AC Power
Battery pack			LCD monitor		Viewfinder on
			on
							Perform step 4 – 5 in “Charging The Battery
BN-VF808U*			1 hr. 50 min.		2 hrs. 15 min.
							Pack” ( pg. 13).
BN-VF815U		3 hrs. 40 min.			4 hrs. 30 min.		NOTE:
BN-VF823U		5 hrs. 30 min.			6 hrs. 45 min.		The provided AC Adapter features automatic
							voltage selection in the AC range from 110 V to
* Provided
							240 V.
NOTES:
							INFORMATION:
● Recording time is reduced significantly under
							The following explanations in this manual
the following conditions:
							supposes the use of LCD monitor in your
• Zoom or Record-Standby mode is engaged
							operation. If you want to use the viewfinder,
repeatedly.
• The LCD monitor is used repeatedly.							close the LCD monitor and pull out the
• The playback mode is engaged repeatedly.							viewfinder fully.
• The LED Light is used.									Language Settings
● Before extended use, it is recommended that
you prepare enough battery packs to cover
3 times the planned shooting time.							The language on the display can be changed.
ATTENTION:							( pg. 34)
Before detaching the power source, make sure									21Select
										LANGUAGE
that the camcorder’s power is turned off. Failure to
do so can result in a camcorder malfunction.
Data Battery System
										ENGLISH
You can check the remaining battery power
and the recordable time.									SET
When the battery is attached, press DATA.							1 Open the LCD monitor fully.
		BATTERY CONDITION
							2 Set the Power Switch to “REC” or “PLAY”
100%				MAX TIME
				LCD			while pressing down the Lock Button located
50%					min		on the switch.
				FINDER			● If set to “REC”, the recording mode should be
	0%				min			set to “M” ( pg. 20).
							3 Press MENU.
● When the Power Switch is set to “OFF”, it is							4 Select “SYSTEM”, press SET or 2.
displayed for approx. 3 seconds if the button							5 Select “LANGUAGE”, press SET or 2.
is pressed and released quickly, and for
approx. 15 seconds if the button is pressed							6 Select the desired language, press SET or
and hold for several seconds.						2.
● When the Power Switch is set to “PLAY” or							7 Press MENU.
“REC”, press DATA again to return to the
normal screen.							Press 1 whenever you want to return to the
● Data battery status cannot be displayed							previous menu screen.

during playback or while recording is in progress.