JVC GR-D790U manual EN D.S.C. Recording, Approximate Number of Storable Images, Memory Card

26 EN D.S.C. RECORDING

	Basic Shooting (D.S.C. Snapshot)	Approximate Number of Storable Images
		● The number increases or decreases depending
		on the Picture Quality/Image Size, etc.
You can use your camcorder as a Digital Still
Camera for taking snapshots. Still images are		Image Size/Picture		SD Memory Card
stored in the memory card.		Quality		8 MB	16 MB		32 MB		64 MB
NOTE:
		640 x 480/FINE	47		95		205		425
Before continuing, perform the procedures listed		640 x 480/STANDARD	160		295		625		1285
below:
● Power ( pg. 13)		Image Size/Picture		MultiMediaCard
● Loading a Memory Card ( pg. 17)		Quality
				8 MB		16 MB		32 MB
● Remove the lens cap.
● Open the LCD monitor fully. ( pg. 8)		640 x 480/FINE		55		105		215
	SNAPSHOT
		640 x 480/STANDARD		190		320		645

VIDEO	Lock Button
MEMORY

VIDEO/

MEMORY

Power Switch

1 Set the VIDEO/MEMORY Switch to “MEMORY”.

2 Set the Power Switch to “REC” while pressing down the Lock Button located on the switch.

●To change the Picture Quality,
pg. 31, 33.

3 Press SNAPSHOT. The “PHOTO” indication appears while the snapshot is being taken.

●To delete unwanted still images, refer to “Deleting Files” (
pg. 29).

●When you do not want to hear the shutter sound, set “MELODY” to “OFF”(
pg. 34).

NOTE:

If shooting is not performed for approx. 5 minutes when the Power Switch is set to “REC” and power is supplied from the battery pack, the camcorder shuts off automatically to save power. To perform shooting again, push back and pull out the viewfinder again or close and re-open the LCD monitor.

CHECK CARD’S WRITE PROTECTION

SWITCH

Appears when you attempt to shoot digital still images when the write protection tab on the SD Memory Card is set to the “LOCK” position.

MEMORY CARD!

Appears if there is no memory card loaded when the SNAPSHOT Button is pressed.