JVC GR-D790U Audio Dubbing, Insert Editing, Editing EN, To hear the dubbed sound during playback

EDITING EN 45

Audio Dubbing

The audio track can be customized only when recorded in the 12-BIT and SP modes.

(
pg. 33)

●Use the provided remote control.

	Speaker
	START/
	STOP
	PAUSE
REW	PLAY
INSERT	STOP
	A.DUB

Stereo

Microphone

1 Play back the tape to locate the point where editing will start, then press PAUSE (8).

2 While holding A. DUB () on the remote control, press PAUSE (8). The “8” indicator appears.

3 Press PLAY (3), then begin “narrating”. Speak into the microphone.

●To pause dubbing, press PAUSE (8).

4 To end Audio Dubbing, press PAUSE (8), then STOP (7).

To hear the dubbed sound during playback

Set “NARRATION” to “ON” or “MIX” (
pg. 35).

NOTES:

●Sound is not heard from the speaker during Audio Dubbing.

●When editing onto a tape that was recorded at 12-BIT, the old and new soundtracks are recorded separately.

●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and out points. The original audio remains unchanged.

●Use the provided remote control.

NOTES:

●Before performing the following steps, make sure that “TIME CODE” for “DISPLAY” in both Recording and Playback Menus is set to “ON”. (
pg. 34, 35)

●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

1 Play back the tape, locate the Edit-Out point and press PAUSE (8). Confirm the time code at this point. (
pg. 20)

2 Press REW (1) until the Edit-In point is located, then press PAUSE (8).

3 Press and hold INSERT ( ) on the remote control, then press PAUSE (8). The “8 ” indicator and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode.

4 Press START/STOP to begin editing.

●Confirm the insert at the time code you checked in step 1.

●To pause editing, press START/STOP. Press it again to resume editing.

5 To end Insert Editing, press START/STOP, then STOP (7) on the remote control.

NOTES:

●Program AE, Effects and Shutter Effects

(
pg. 41) can be used to spice up the scenes being edited during Insert Editing.

●During Insert Editing, the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Editing stops.

ADVANCED FEATURES