POWER Switch
POWER Lamp
Lock Button
Operation
Switch
MENU Wheel
EN11
Recording Mode Setting
Set the tape recording mode depending on your preference.
1 Set the Operation Switch to “ ” and set the POWER
Switch to “ ” while pressing down the Lock Button located on the switch, then open the LCD monitor fully or pull out the viewfinder fully. The POWER lamp lights and the camcorder is turned on.
2 Press the MENU wheel. The Menu Screen appears.
3 Rotate the MENU wheel to select “ ” and press it. “CAMERA MENU” appears.
4 Rotate the MENU wheel to select “REC MODE” and press it. The Sub Menu appears. Select “SP” or “LP” by rotating the MENU wheel and press it. Rotate the MENU wheel to select “1RETURN”, and press it
Display
CAMERA MENU 1RE TURN
REC MODE SP
SOUND MODE L P
ZOOM
SNAP MODE
GA I N UP
BEEP / TAL L Y
I D NUMBER
DEMO . MODE
Menu Screen
Sub Menu
twice. The Menu Screen closes.
•Audio Dubbing ( pg. 76) is impossible on a tape recorded in the LP mode.
•“LP” (Long Play) is more economical, providing 1.5 times the recording time.
NOTES:
●If the recording mode is switched during recording, the playback picture will be blurred at the switching point.
●It is recommended that tapes recorded in the LP mode on this camcorder be played back on this camcorder.
●During playback of a tape recorded on another camcorder, blocks of noise may appear or there may be momentary pauses in the sound.