JVC GR-DVX9 specifications 84EN

84EN TROUBLESHOOTING (cont.)

SYMPTOM

45.The LCD monitor, the viewfinder and the lens have become dirty

(ex. fingerprints).

46.An unusual mark appears.

47.An error indication (E01 — E06) appears.

48.The charger indicator on the AC Power Adapter/Charger does not light.

49.Picture does not appear on the LCD monitor.

50.When the image is printed from the printer, a black bar appears at the bottom of the screen.

51.When the camcorder is connected via the DV connector, the camcorder does not operate.

52.During transport, the lens cover opens.

53.The MultiMediaCard cannot be removed from the camcorder.

POSSIBLE CAUSES	CORRECTIVE ACTION
45.	45. • Wipe them gently with soft
————	cloth. Wiping strongly can
	cause damage ( pg. 78).
46.	46. • Check the section of the
————	manual that explains LCD
	monitor/viewfinder indica-
	tions ( pg. 88 – 92).
47. • A malfunction of some kind	47. • Remove the power supply
has occurred. In this case the	(battery pack, etc.) and wait a
camcorder’s functions	few minutes for the indication
become unusable.	to clear. When it does, you
	can resume using the
	camcorder.
	If the indication remains even
	though you repeat the above
	two or three times, please
	consult your nearest JVC
	dealer.
48. • The temperature of the battery	48. • To protect the battery, it is
is extremely high/low.	recommended to charge it in
• Charging is difficult in places	places with a temperature of
subject to extremely high/low	10° C to 35° C ( pg. 93).
temperatures.
49. • The viewfinder is pulled out.	49. • Push the viewfinder back in.
• The LCD monitor's brightness	• Adjust the brightness of the
setting is too dark.	LCD monitor ( pg. 16).
	• If the monitor is tilted upward
	180 degrees, open the
	monitor fully ( pg. 16).
50. • This is not a malfunction.	50. • By recording with “DIS”
	activated ( pg. 28) this can
	be avoided.
51. • The DV cable was plugged/	51. • Turn the camcorder’s power
unplugged with power turned	off and on again, then operate
on.	it.
52.	52. • Do not subject the camcorder
————	to shock or excessive
	vibration during transport.
	• Turn the camcorder on and
	off. The lens cover closes.
53.	53. • Push in the MultiMediaCard a
————	few more times ( pg. 12).