76EN | USING THE REMOTE CONTROL UNIT (cont.) |
Display
6e Audio Dub
Standby mode
POWER Switch
Lock Button
Speaker
Stereo microphone
Remote sensor
External microphone input connector
Located beneath the cover.
AV OUT (headphone) connector
DISPLAY
A.DUB
PLAY
PAUSE
STOP
Audio Dubbing
The audio track can be customized only when recorded in the
NOTES:
●Audio Dubbing is not possible on a tape recorded in 16- bit audio, on a tape recorded in the LP mode or on a blank portion of a tape.
●To perform Audio Dubbing while watching on the television, make connections ( pg. 56).
1 Play back the tape to locate the point where editing will start, then press PAUSE (6).
2 While holding A.DUB (e) on the remote control, press PAUSE (6). “6e” appears.
3 Press PLAY (4) , then begin “narrating”. Speak into the microphone.
•To pause dubbing, press PAUSE (6).
4 To end Audio Dubbing, press PAUSE (6), then STOP (5).
To hear the dubbed sound during playback . . .
.... set “12BIT MODE” to “SOUND 2” or “MIX” in the
Menu Screen ( pg. 41, 42).
NOTES:
●Audio dubbing is also possible using an optional microphone connected to the MIC connector on the Docking Station.
●Sound is not heard from the speaker during Audio Dubbing. To hear sound, connect optional headphones to the AV OUT connector.
●While an optional microphone is connected, the
●When editing onto a tape that was recorded at
●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.
●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.
●If you change from
●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in
audio or a blank portion, Audio Dubbing stops ( pg. 91).
●For
first set
( pg. 41). You can hear sound from the video unit using optional headphones.