INDEX Docking Station | EN85 |
57
6
1
2
3!
4
8 9
0
1PC Connector [DIGITAL STILL] ............ pg. 58
2J Terminal/Edit Connector
[JLIP (Joint Level Interface Protocol)
(EDIT)] ................................................ pg. 71
•Connect to a
NOTE:
Make sure that the camcorder is turned on while connecting the camcorder to a PC using the Docking Station’s JLIP connector. If the camcorder is turned off (because the POWER Switch is set to “OFF” or due to Auto Shut Off* etc.) while the JLIP programme software is used, it will be impossible to control the connected devices from the computer. In such a case, first try turning the camcorder on again, or unplug the JLIP connec- tion cable from the Docking Station’s JLIP connector. Then, initialise or run the software again.
*Auto Shut Off:
If 5 minutes elapse in the Record-Standby mode
or in the Pause mode, the camcorder’s power shuts off automatically to conserve energy.
•Connect the editing cable when performing Random Assemble Editing ......... pg. 70 – 75
3PRINTER Connector
Connect to the optional printer equipped with a PRINT DATA connector. Refer to the separate
“FOR OWNERS OF AN OPTIONAL PRINTER” instruction sheet.
4External Stereo Microphone Input
Connector [MIC] | pg. 76 |
5 Stud | pg. 56 |
6 Screw | pg. 56 |
7Multi Connector
The Docking Station can be connected with this camcorder through this connector. Never touch it with your hand or hit it with a hard object; if the pins are damaged, the connectors will become unusable due to contact failure.
8
[S] | pg. 56, 71 |
9Video Input/Output Connector
[VIDEO] | pg. 56, 71 |
0Audio Input/Output Connectors
[AUDIO L/R] | pg. 56, | 71 |
! Screw Knob | pg. | 56 |
To attach the camcorder, tighten this clockwise. |