JVC GR-DVX9 18EN, Snapshot For Video Recording, Snapshot Mode Selection, Snapshot Recording

Page 18

18EN

RECORDING Basic Recording For Video (cont.)

MENU Wheel

MODE Dial

POWER Switch

Lock Button

Operation Switch

SNAPSHOT Button

Display

 

 

 

CAMERA MENU

 

 

Menu Screen

 

 

 

 

 

 

 

1RE TURN

 

 

 

 

 

REC MODE

 

 

 

 

 

 

SOUND MODE

 

 

 

 

 

 

ZOOM

 

 

 

 

 

 

SNAP MODE

FUL L

 

 

 

 

GA I N UP

P I N – UP

 

 

 

 

BEEP / TAL L Y

 

 

 

 

 

 

I D NUMBER

 

 

 

 

 

 

DEMO. MODE

 

 

 

 

 

 

 

 

 

 

 

 

FULL Snapshot mode with no frame*

PIN-UP

Pin-Up mode

*There is the sound effect of a shutter closing.

When the MODE Dial is set to “ ”, snapshot recording will be performed with higher quality ( pg. 22).

Snapshot (For Video Recording)

This feature lets you record still images that look like photographs onto a tape.

SNAPSHOT MODE SELECTION

Set the POWER Switch to “

” while pressing

1 down the Lock Button located on the switch and the

MODE Dial to “VIDEO” or “

”, then set the

Operation Switch to “ ”. Pull out the viewfinder fully or open the LCD monitor fully.

2 Press the MENU wheel. The Menu Screen appears.

3 Rotate the MENU wheel to select “ ”. Press it and “CAMERA MENU” appears.

4 Rotate the MENU wheel to select “SNAP MODE”, then press it.

5 Rotate the MENU wheel to select the desired Snapshot mode, then press it.

Rotate the MENU wheel to select “1RETURN” and press it twice. The Menu Screen closes.

SNAPSHOT RECORDING

1 Press SNAPSHOT.

If you press during Record-Standby . . .

.... “PHOTO” appears and a still image will be

recorded for approx. 6 seconds, then the camcorder re-enters the Record-Standby mode.

If you press during Recording . . .

.... “PHOTO” appears and a still image will be

recorded for approx. 6 seconds, then the normal recording resumes.

•To use the flash,  pg. 30.

Motor Drive Mode

Keeping SNAPSHOT pressed provides an effect similar to serial photography. (Interval between still images: approx. 1 second)

NOTES:

●To remove the shutter sound,  “BEEP/TALLY” on pg. 27.

●If Snapshot recording is not possible, “PHOTO” blinks when SNAPSHOT is pressed.

●If Programme AE with special effects ( pg. 36) is engaged, certain modes of Programme AE with special effects are disabled during Snapshot recording. In such a case, the icon blinks.

●If SNAPSHOT is pressed when “DIS” is set to “ON” (  pg. 28), the Stabiliser will be disabled.

●To dub images recorded on a tape to a MultiMediaCard,  pg. 65.

●To reduce the Red-Eye effect in the subject’s eyes when the flash fires,  pg. 30.

●During playback as well, all snapshot modes are available

when “ COPY” is set to “OFF” in the Menu Screen ( pg. 41).

●When a headphone set is connected to the headphone connector, the shutter sound is not heard from the speaker, however it is recorded onto the tape.

Page 17 Page 19
Image 18
Page 17 Page 19
Contents GR-DVX10 GR-DVX9 Dear Customer It is recommended that youSome DO’S and DON’TS on the Safe USE of Equipment RCA plug cable Cable Adapter Remote Control Unit RM-V716U Core Filter xCleaning Cloth DC CordStopper How To Attach Core FiltersRelease the stoppers on both ends of the Core Filter Wind onceLithium-ion is vulnerable in colder temperatures PowerCharging the Battery Pack Benefits Of Lithium-Ion BatteriesTo Detach The Battery Pack Using the Battery PackUsing AC Power While sliding down BATT. RELEASE, detach itDioptre Adjustment Control Grip AdjustmentViewfinder Adjustment Tripod MountingSet the Operation Switch to and set the Power Date/Time SettingsBuilt-in Clock’s Rechargeable Lithium Battery Power Switch Power Lamp Lock Button Operation Menu WheelLoading/Unloading a Cassette OPEN/EJECT Switch Erase protection tab10EN Cassette holder coverDisplay Recording Mode SettingEN11 Menu Screen Sub Menu12EN Loading a MultiMediaCardTo Unload a MultiMediaCard Mode Dial to Picture Quality/Size Mode SettingSet the Power Switch to While pressing EN13Operation Switch Position Manual Operation ModePower Switch Position 14ENEN15 Mode Dial PositionProgressive Mode FunctionPress START/STOP To Adjust The Brightness Of The Display16EN To Stop RecordingSELF-RECORDING EN17Journalistic Shooting Self-RecordingSnapshot For Video Recording Snapshot Mode Selection18EN Snapshot RecordingTo Delete Unwanted Still Images Basic Shooting SnapshotEN19 To Remove The Shutter SoundZoom Slide the Power Zoom Lever towards T20EN Zoom OutWhen a blank portion is recorded on a tape EN21Proper recording Progressive Mode Recording To End Progressive Mode RecordingRegular shooting of moving images Description of Progressive Scan CCDEN23 Frame Scan a Scan BStill image Dual ShootingFocus Button Fully-pressed PositionEN25 Feature Auto FocusFeature Manual Focus To obtain correct focusGo to step Power Switch Lock Button Operation Switch Menu WheelSee pg Menu ScreenMenu Screen Explanations EN27After viewing demo, set to OFF Refer to Self-Timer  pgDemonstration will resume Automatic demonstration will not take placeEN29 Snapshot Flash If Auto Is SelectedEN31 Flash Brightness AdjustmentPower Switch Lock Button Operation Switch Menu Wheel DisplaySelf-Timer Mode Dial to Video Second RecordingEN33 Picture Wipe or Dissolve Selection Fade/Wipe EffectsFADE/WIPE Selection To Deactivate The Selected EffectEN35 Fader And Wipe MenuMenu Effect To Deactivate The Selected Mode Programme AE With Special EffectsDigital Sound Effects Sound Effect Mode SelectionTo cancel recording the sound effect midway EN37Exposure Control Iris LockEN39 White Balance AdjustmentManual White Balance Operation To Return To Automatic White BalancePower Zoom Lever VOL Menu Wheel Speaker Lock Button To Control The Speaker VolumeAvailable only with the remote control provided  pg Rewind ButtonEN41 42EN Playback SoundDisplay EN43 To cancel Blank Search midwayBlank Search Video Menu appearsMail Clip Recording To cancel E-Mail Clip Recording44EN To view video clips stored in a MultiMediaCardImages shot with the camcorder are automatically Normal PlaybackAuto Playback Numbered, then stored in numerical orderType of file Protect icon Power Switch Lock Button Menu WheelIndex Screen DirectoryIf you press Index twice Index PlaybackEN47 If you press Index three timesTo Protect a File 48ENProtecting Files To Remove ProtectionEN49 Power Switch Lock ButtonDeleting Files To Select a File by Browsing Files Stored in MemoryInitialising a MultiMediaCard Power Switch Menu Wheel Display50EN You can initialise a MultiMediaCard anytimeTo Make The Print Frame Disappear Superimposing a Print FrameEN51 Press Print FramePrint Frame Deletion Set the Power Switch to52EN Lock Button Delete Index Screen Deletion ConfirmationTo Delete ALL Print Frames To Reset The Setting 54ENTo Print ALL Still Images ONE Print for Each To Print by Selecting Still Images and NO. of Prints To Reset The No. Of PrintsEN55 Perform steps 1 through 4 on pgCamcorder 56ENDocking Station with the stud hole Tighten the screwIf using a VCR . . . go to step If not . . . go to step EN57Make sure all units are turned off 58EN Connection To a Personal ComputerWith a DV input Connection To a Video Unit Equipped With a DV ConnectorEN59 Core filter Digital PrinterTo use this camcorder as a player 60ENDubbing To a VCR For GR-DVX10 owners onlyDubbing From a VCR EN6162EN To DV OUT Core filter DV cable optionalPlay Stop EN63 To DV IN/OUT Core filter DV cable optional To DV OUTIndicator disappears when dubbing is complete 64ENDubbing Images Stored In a MultiMediaCard To a Tape Menu Wheel Power Switch Lock Button Dubbing Images Recorded On a Tape To a MultiMediaCardEN65 Tab Installing The Batteries66EN Remote sensorEN67 Functions ButtonsFeature Playback Zoom Feature Slow-Motion PlaybackFeature Frame-By-Frame Playback 68ENFeature Playback Special Effects EN69Effect Select Menu VCR Recording deck 70ENSET REMOTE/VCR Code You are now ready to try Random Assemble EditingEN71 Make ConnectionsProgramme 72ENSelect Scenes Editing MenuEN73 Automatic Editing to VCRDiagnosing VCR/CAMCORDER Timing 74ENFor More Accurate Editing Tvvcr Recording deckAdjustment of VCR/CAMCORDER Timing EN75Recording deck Audio Dubbing Set 12BIT Mode to Sound 2 or MIX Menu Screen  pg76EN To hear the dubbed sound during playbackAudio Dubbing Using Digital Sound Effects EN7778EN Cleaning The CamcorderPush Here OPEN/EJECT Switch Hatch Lens blower After UseTroubleshooting Corrective ActionTroubleshooting 80ENEN81 Is ending Dissolve before beginning82EN White Balance cannot be activatedEN83  pg84EN Multi Connector If 5 minutes elapse in the Record-Standby modePrinter Connector EN8586EN EN87 Displays the Time Code 88ENAppears while the tape is running Order of qualityEN89 Displays the sound mode LCD Monitor/Viewfinder Indications During Video PlaybackLCD Monitor/Viewfinder Indications During D.S.C. Playback EN91 While the Power Switch is set to 92ENDeleted Pack, be sure to read the Terminals following cautions To prevent damage and prolong service lifeEN93 To avoid hazards94EN About moisture condensation EN95To protect the unit, do not Serious malfunctioning96EN EN97 Print Frame Deletion  pg98EN EN99 EG/EK
Top Page Image Contents