JVC GR-DVP7 With a DV in Connector Digital Dubbing, Dubbing To a Video Unit Equipped

EN 63

Dubbing To A Video Unit Equipped

With A DV IN Connector

(Digital Dubbing)

It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.

1	Make sure all units are turned off.
2	Connect this camcorder to a video unit equipped
	with a DV input connector using a DV cable as
3	shown in the illustration.
	Set this camcorder’s VIDEO/MEMORY Switch to
4	“VIDEO”.
	Set this camcorder’s Power Switch to “P”
	while pressing down the Lock Button located on
5	the switch.
	Turn on the video unit’s power.
6	Insert the source cassette in this camcorder.
7	Insert the recording cassette in the video unit.
8	Press 4/9 on this camcorder to start playback of
9	the source cassette.
	At the point you want to start dubbing, engage
	the video unit’s Record mode.
10 To pause dubbing, engage the video unit’s
	Record-Pause mode and press 4/9 on this
	camcorder.

Connector

Cover**

Core filter

To DV IN

To DV IN/OUT*

DV cable (optional)

11 Repeat steps 8 – 10 for additional editing. Stop

the video unit and camcorder.

NOTES:

● It is recommended to use the AC Power Adapter/

Charger as the power supply instead of the

battery pack. ( pg. 11)

● If the remote control is used when both the player

and recorder are JVC video units, both units will

perform the same operation. To prevent this from

happening, press the buttons on both units.

● If a blank portion or disturbed image is played

back on the player during dubbing, the dubbing

may stop so that an unusual image is not dubbed.

● Even though the DV cable is connected correctly,

sometimes the image may not appear in step 9. If

this occurs, turn off the power and make

connections again.

● If “Playback Zoom” ( pg. 68) or “Playback

Special Effects” ( pg. 69) is attempted or

SNAPSHOT is pressed during playback, only the

Video unit equipped with

DV connector

*DV IN/OUT: GR-DVP7

DV OUT: GR-DVP5

**When connecting the cable, open the cover.

original playback image recorded on the tape is

output from the DV IN/OUT (GR-DVP7) or DV

OUT (GR-DVP5) connector.

● When using a DV cable, be sure to use the

optional JVC VC-VDV204U DV cable.