JVC GR-DVP7 instruction manual 70 EN, Audio Dubbing, While holding A. DUB On the remote

70 EN USING THE REMOTE CONTROL UNIT (cont.)

Audio Dubbing

The audio track can be customised only when recorded in the 12-bit and SP modes. ( pg. 43)

Stereo microphone

Headphone
connector	Speaker

Remote sensor

A.DUB

PLAY

PAUSE

STOP

1Play back the tape to locate the point where editing will start, then press PAUSE (9).

2 While holding A. DUB	9D
(D) on the remote	MIC
control, press PAUSE
(9). The “9D”
indicator appears.

3Press PLAY (U), then begin “narrating”. Speak into the microphone.

● To pause dubbing, press PAUSE (9).

4To end Audio Dubbing, press PAUSE (9), then STOP (8).

To hear the sound during Audio Dubbing...

Connect optional headphones to the headphone connector or use the S/AV connector, and set the “12BIT MODE” to the desired mode; •“SOUND 1” for the playback sound. •“SOUND 2” for the dubbed sound.

•“MIX” for the Playback and dubbed sound.

To hear the dubbed sound during playback… Set “12BIT MODE” to “SOUND 2” or “MIX”. ( pg. 38, 50)

NOTES:

●When editing onto a tape that was recorded at

12-bit, the old and new soundtracks are recorded separately.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●If you change from 12-bit to 16-bit in mid- recording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit audio or a blank portion, Audio Dubbing stops.

●To perform Audio Dubbing while watching on the television, make connections. ( pg. 24, 25)