JVC GR-DVP7 instruction manual 72 EN, Insert Editing

72 EN USING THE REMOTE CONTROL UNIT (cont.)

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.

Remote sensor

4Press START/STOP to begin editing.

●Confirm the insert at the time code you checked in step 1.

●To pause editing, press START/STOP. Press it again to resume editing.

5To end Insert Editing, press START/STOP, then STOP (8).

NOTES:

●Program AE with special effects ( pg. 38, 41) can be used to spice up the scenes being edited during Insert Editing.

●During Insert Editing, the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops. ( pg. 100, 101)

START/STOP

INSERT

REW PLAY

STOP

NOTES:

PAUSE

● Before performing the following steps, make sure that “TIME CODE” is set to “ON”. ( pg. 38, 48)

● Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

● To perform Insert Editing while watching in the television, make connections. ( pg. 24, 25)

1 Play back the tape, locate the Edit-Out point and press PAUSE (9). Confirm the time code at this point. ( pg. 38, 48)

2 Press REW (3) until the Edit-In point is located, then press PAUSE (9).

3 Press and hold INSERT

(I) on the remote

9I

control, then press PAUSE (9). The “9I” indicator and the Time Code (min.:sec.)

appear and the 12 : 34 camcorder enters

Insert-Pause mode.