JVC GR-DVP7 instruction manual 76 EN, Automatic Editing To VCR

T I ME CODE TOTAL

1 6 : 3 0

9 : 39

76 EN USING THE REMOTE CONTROL UNIT (cont.)

Automatic Editing To VCR

Recording Start/

Stop Button

Remote sensor

START/STOP

PAUSE

R.A.EDIT

ON/OFF

VCR REC

STBY

13Rewind the tape in the camcorder to the beginning of the scene you want to edit and press PAUSE (9).

14Point the remote control towards the VCR’s remote sensor and press VCR REC STBY (79), or manually engage the VCR’s Record-Pause mode.

15 Press START/STOP		I N		OUT		MODE
on the remote control.	1	00 : 2 5 ~		02	: 05		– –
Editing proceeds as	2	07 : 18 ~		08 : 31 – – – –
	3 – –	03 : 33 ~		05 : 53
programmed, right	4	09 : 30	~	13 : 15
	5	15 : 55	~	16 : 29		– – – –
through to the end of	6 – –	– – : – –	~
	7		~
the last registered
	8		~

scene.

●When dubbing is

complete, the camcorder enters the Pause mode, and the VCR enters its Record-Pause mode.

●If you do not register an Edit-Out point, the tape will be dubbed all the way to the end automatically.

●If you operate the camcorder during automatic editing, the VCR will enter its Record-Pause mode and automatic editing will stop.

16Engage the Stop modes for the camcorder and the VCR.

To make the R.A.Edit counter display disappear, press R.A.EDIT ON/OFF on the remote control.

NOTES:

●Pressing R.A.EDIT ON/OFF on the remote control clears all settings registered during Random Assemble Editing.

●When the editing cable is connected to the remote control’s PAUSE IN connector during dubbing, make sure the remote control is pointed at the VCR’s sensor, and the path between the two is unobstructed.

●Random Assemble Editing may not function properly when using a tape including several duplicated time codes. ( pg. 21)