Panasonic DMC-XS1EB, DMC-XS1GN, DMC-XS1GF, DMC-XS1GC, DMC-XS1P Removal of the CCD FPC Unit, Fig. D14

Page 28

8.4.Removal of the CCD FPC Unit

When remove the CCD FPC Unit once (the screw (G) is loos- ened even a little), the optical tilt adjustment is required.

When loosen the screw (G), necessary the optical tilt adjust- ment at the end of assembling. (Refer to item “9.3.2.”)

To prevent the CCD FPC Unit from catching the dust and dirt, do not remove the CCD FPC Unit except for replacing.

(Fig. D14)

28

Image 28

Contents Model No. DMC-XS1P Table of Contents Safety Precautions General GuidelinesLeakage Current Cold Check Leakage Current Hot Check See FigureHow to Discharge the E.Capacitor on Flash Top P.C.B Fig. F1How to Recycle the Lithium Ion Battery U.S. Only Service Navigation Introduction Important NoticeRecommended Lead Free Solder Service Parts Route General Description About Lead Free Solder PbFHow to Define the Model Suffix Ntsc or PAL model Defining methodsCancellation of Initial Settings Temporary cancellation of Initial SettingsTurn the Power on Turn the Power on Display the Initial Setting Choose the model suffix in Initial Settings Refer to CautionDefault setting After Initial Settings ConfirmationSpecifications Location of Controls and Components Page Service Mode Error Code Memory FunctionHow to display Execute the error code display modeError Code List How to exit from Error Code display mode Important notice about Error Code List About * indicationAbout ? indication 18*0 0?01 to 18*0 0?60 Service Fixture and Tools Service Fixture & ToolsWhen Replacing the Main P.C.B Service Position Disassembly Flow Chart Disassembly and Assembly InstructionsP.C.B. Location Disassembly Procedure Removal of the Rear Case UnitRemoval of the Rear Op Plate Unit Fig. D2Removal of the Front Case Unit Removal of the LCD Unit Fig. D4Removal of the Frame Plate Removal of the Top Case UnitRemoval of the Main P.C.B. SpeakerFig. D12 Removal of the Battery Door Unit Fig. D13Removal of the CCD FPC Unit Fig. D14Measurements and Adjustments Initial Setting ReleaseIntroduction Before Disassembling the unitRombackup Method of Non-PC backup Flash-ROM Data BackupLight Box Details of Electrical Adjustment How to execute the Electrical AdjustmentStartup Electrical Adjustment mode Status Adjustment Flag SettingExecute Adjustment Case of OIS Adjustment Finalizing the AdjustmentAdjustment Specifications Page After Adjustment Initial SettingMaintenance Cleaning Lens and LCD PanelBlock Diagram Overall Block DiagramFlash / Top Block Diagram Sub Operation Block DiagramWiring Connection Diagram Interconnection Diagram