Panasonic DMC-XS1EE, DMC-XS1GN, DMC-XS1GF, DMC-XS1GC, DMC-XS1PU After Adjustment, Initial Setting

Page 35

9.4.After Adjustment

9.4.1.Initial Setting

Since the initial setting has been released to execute the built-in adjustment software, it should be set up again before shipping the camera to the customer.

Refer to the procedure described in “3.4.2. INITIAL SETTINGS” for details.

[ IMPORTANT ]

1.The initial setting should be done again after completing the alignment. Otherwise, the camera will not work properly. Therefore as a warning, the camera display a warning symbol “ ! ” on the LCD monitor every time the camera is turned off.

2.Confirm that status of all adjustment flag show “F”. Even if one of the adjustment flag shows “0”, initial setting programmed is never executed.

35

Image 35

Contents Model No. DMC-XS1P Table of Contents Leakage Current Hot Check See Figure Safety PrecautionsGeneral Guidelines Leakage Current Cold CheckFig. F1 How to Discharge the E.Capacitor on Flash Top P.C.BHow to Recycle the Lithium Ion Battery U.S. Only Introduction Important Notice Service NavigationGeneral Description About Lead Free Solder PbF Recommended Lead Free Solder Service Parts RouteDefining methods How to Define the Model Suffix Ntsc or PAL modelTurn the Power on Turn the Power on Temporary cancellation of Initial SettingsCancellation of Initial Settings Choose the model suffix in Initial Settings Refer to Caution Display the Initial SettingConfirmation Default setting After Initial SettingsSpecifications Location of Controls and Components Page Execute the error code display mode Service ModeError Code Memory Function How to displayError Code List About ? indication 18*0 0?01 to 18*0 0?60 Important notice about Error Code List About * indicationHow to exit from Error Code display mode When Replacing the Main P.C.B Service Fixture & ToolsService Fixture and Tools Service Position P.C.B. Location Disassembly and Assembly InstructionsDisassembly Flow Chart Removal of the Rear Case Unit Disassembly ProcedureFig. D2 Removal of the Rear Op Plate UnitFig. D4 Removal of the Front Case Unit Removal of the LCD UnitRemoval of the Top Case Unit Removal of the Frame PlateSpeaker Removal of the Main P.C.B.Fig. D12 Fig. D13 Removal of the Battery Door UnitFig. D14 Removal of the CCD FPC UnitBefore Disassembling the unit Measurements and AdjustmentsInitial Setting Release IntroductionLight Box Flash-ROM Data BackupRombackup Method of Non-PC backup Status Adjustment Flag Setting Details of Electrical AdjustmentHow to execute the Electrical Adjustment Startup Electrical Adjustment modeFinalizing the Adjustment Execute Adjustment Case of OIS AdjustmentAdjustment Specifications Page Initial Setting After AdjustmentCleaning Lens and LCD Panel MaintenanceOverall Block Diagram Block DiagramSub Operation Block Diagram Flash / Top Block DiagramInterconnection Diagram Wiring Connection Diagram