Camera Recording
Recording via EVF or LCD Monitor
View recording scene on EVF (Electronic Viewer Finder) or LCD (Liquid Crystal Display) monitor.
1
Before you begin...
•Connect Camcorder to power source.
•Insert cassette with record tab (page 12).
1 Press
2 Set POWER to
CAMERA.
CAUTION
Rotating partially open LCD monitor may block cassette door and damage Camcorder body.
4, A, B
• Be sure POWER is fully turned to CAMERA position.
•EVF or LCD monitor
turns on/off by the POWER switch.
•Both EVF and LCD monitor turn on when LCD is at 180° (see above left). This allows both you and the subject to view the recording.
3
Built-in
Microphone
LCD : Adjust LCD monitor brightness level. See “To adjust LCD BRIGHT” below.
EVF : Look into EVF and adjust VISION ADJUSTMENT to your preference.
3VISIONADJUSTMENT
To adjust LCD BRIGHT
APress MENU for MENU mode.
Press UP or DOWN to select
LCD BRIGHT .
BPress M.FOCUS for
LCD BRIGHT SETTING menu.
Press UP or DOWN to adjust LCD monitor brightness level.
2, 6
5
4 Set REC MODE to “SP” or “SLP” in the CAMERA MODE Menu (page 14).
5 Press RECORD/PAUSE to start or pause recording.
6 Set POWER to OFF when finished.
•To remove the cassette, slide the TAPE EJECT switch (page 12).
Note:
•When Camcorder is aimed at excessively bright objects, or bright lights, a vertical bar may appear in the picture. This is normal for the CCD
•Using LCD monitor reduces battery operation time. Return LCD monitor to locked position when not in use.
18
For assistance, please call :