Axis Communications Q6045S user manual Storage, UPnPTM, RTP/H.264, Bonjour, SD Card

Page 53

AXIS Q6045–S PTZ Dome Network Camera

System Options

Note

If HTTPS is enabled, SNMP v1 and SNMP v2c should be disabled.

Traps for SNMP v1/v2 are used by the Axis product to send messages to a management system on important events and status changes. Check Enable traps and enter the IP address where the trap message should be sent and the Trap community that should receive the message.

The following traps are available:

Cold start

Warm start

Link up

Authentication failed

SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.

To use SNMP v3, HTTPS must be enabled, see HTTPS, on page 46. To enable SNMP v3, check the box and provide the initial user password.

Note

The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see Reset to Factory Default Settings, on page 57.

UPnPTM

The Axis product includes support for UPnPTM. UPnPTM is enabled by default and the product is automatically detected by operating systems and clients that support this protocol.

UPnPTM can be disabled under System Options > Network > UPnPTM.

RTP/H.264

The RTP port range and multicast settings are configured under System Options > Network > RTP.

The RTP port range defines the range of ports from which the video ports are automatically selected. For multicast streams, only certain IP addresses and port numbers should be used.

Select Always Multicast Video to start multicast streaming without opening an RTSP session.

Bonjour

The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating systems and clients that support this protocol.

Bonjour can be disabled under System Options > Network > Bonjour.

Storage

SD Card

The Axis product supports SD cards with up to 64 GB of storage. For best recording performance, use an SDHC or SDXC card with speed class 10.

NOTICE

To prevent corruption of recordings, the SD card should always be unmounted before it is ejected.

The Axis product supports SD cards with the following file systems:

53

Image 53
Contents Axis Q6045-S PTZ Dome Network Camera Legal Considerations About this DocumentLiability Intellectual Property RightsLearn More SupportAxis Q6045-S PTZ Dome Network Camera Table of ContentsMedia Converter Switch Connectors Performance Considerations Support Advanced Reset to Factory Default SettingsPressurize the Camera Recommended Hardware OverviewHardware Overview LED Indicators Connectors and ButtonsMulti-connector SD Card SlotMedia Converter Switch Connectors Hardware Overview Media Converter SwitchConnector internal 2-pin I/O terminal block Network Connector Dip SwitchesDip switch position Description Media Converter Switch LED IndicatorsAccessing the Product Accessing the ProductAccess from a Browser Start a browser Internet Explorer, Firefox, SafariClick Use Https Accessing the Product Access from the InternetSet the Root Password Go to Setup Events Accessing the Product Live ViewControls on the Live View Manual TriggerPTZ Controls Axis Media Control viewer toolbarAxis Q6045-S PTZ Dome Network Camera Media Streams How to Stream H.264Media Streams Axis Media Control AMCQuickTimeTM. The following paths can be used Alternative Methods of Accessing the Video StreamAxis Q6045-S PTZ Dome Network Camera Basic Setup Setting Up the ProductSetting Up the Product Video VideoVideo Stream Pixel CounterStream Profiles Click Save to apply the new settingsImage 264Exposure Settings Camera SettingsImage Appearance White BalanceOverlay Image SettingsOverlay Image Go to Video Video Stream and select the Image tabGo to Events Action Rules Using Overlay Text in an Action RulePrivacy Mask Axis Q6045-S PTZ Dome Network Camera Live View Config Live View ConfigViewer Settings Default Viewer for BrowsersUser Defined Links Output ButtonsGo to Setup Live View Config Go to PTZ Preset Positions Preset PositionsPTZ Pan Tilt Zoom PTZ Pan Tilt ZoomPTZ Pan Tilt Zoom Gatekeeper ConfigurationAutotracking Exclude AreasTour Recording Guard TourTo add a guard tour To add a recorded tourLimits Osdi ZonesAdvanced Controls Operator Same as administrator but with lower priorityControl Queue Detectors Set Up Motion Detection WindowsDetectors Shock DetectionMotion Detection Parameters Object RemovedObject Counter Enter/Exit DetectorFence Detector Applications Install ApplicationApplications Application LicensesAxis Q6045-S PTZ Dome Network Camera Events Input SignalEvents DetectorsStorage Setting Up an Action RuleSystem TimeFallback Action RecipientsGo to Events Action Rules and click Add RecipientSchedules Setting Up an Email RecipientGo to Events Recipients and click Add Go to Events Schedules and click AddGo to Events Recurrences and click Add RecurrencesRecordings RecordingsRecording List Continuous RecordingLanguages LanguagesSystem Options System OptionsSecurity UsersGo to System Options Security Ieee IeeeCertificates Go to Setup System Options Security Certificates Basic TCP/IP SettingsDate & Time NetworkIPv6 Address Configuration IPv4 Address ConfigurationAssign IP Address Using ARP/Ping ARP/PingAxis Internet Dynamic DNS Service Advanced TCP/IP SettingsAxis Internet Dynamic DNS Service requires IPv4 DNS ConfigurationHost Name Configuration NTP ConfigurationLink-Local IPv4 Address NAT traversal port mapping for IPv4FTP QoS Quality of ServiceUPnPTM StorageRTP/H.264 BonjourGo to System Options Storage and click SD Card Network ShareTo add a network share Go to System Options Storage Click Network ShareSupport MaintenanceSystem Options Ports & Devices Logs & Reports Plain ConfigScripting File UploadSystem Options Reset to Factory Default Settings Multi-Connector Cable Multi-Connector CableFunction Pin wire Specifications Activated, floating unconnected when Drain, 100 mATroubleshooting TroubleshootingEmergency Recovery Procedure Checking the FirmwareProblems setting the IP address Symptoms, Possible Causes and Remedial ActionsWhen using ARP/Ping Product cannot be accessed from a browserBasic Product is accessible locally but not externallyProblems with streaming H.264 Video Camera Settings Video and image problems, generalStorage and disk management problems Media converter switchTechnical Specifications Technical SpecificationsInstallation aid Function/group Specifications System ApplicationMaintenance Integration Programming InterfacePower Function/group Specifications General CasingConnectors WeightExternal Connectors Technical Specifications Media Converter Switch ConnectorsCamera Connectors Collector 100 mA Performance ConsiderationsM1.7