Axis Communications Q6044-C user manual Multi-Connector Cable, Function Pin wire Specifications

AXIS Q6044-C PTZ Dome Network Camera

Multi-Connector Cable

Multi-Connector Cable

The supplied multi-connector cable is required in order to maintain the camera’s IP rating.

The multi-connector cable is connected to the camera’s multi-connector, see Hardware Overview on page 6 . The wires are connected to the supplied media converter switch, see Media Converter Switch on page 8 . The cable provides the following signals:

• DC power to camera

• Network (Ethernet 10/100Base-T)

• Input/Output (I/O)

Function	Pin – wire		Notes	Specifications
Configurable (Input	2 – blue		Digital input – Connect to pin 8 to activate, or	0 to max 30 V DC
or Output)	7	– yellow	leave floating (unconnected) to deactivate.
			Digital output – Connected to pin 1 when	0 to max 30 V DC, open
			activated, floating (unconnected) when	drain, 100 mA
			deactivated. If used with an inductive load, e.g. a
			relay, a diode must be connected in parallel with
			the load, for protection against voltage transients.
RX+	3	– green/white	Ethernet – receiving
RX-	4	– green	Ethernet – receiving
TX+	5	– orange/white	Ethernet – transmitting
TX-	6	– orange	Ethernet – transmitting
0 V DC (-)	8	– black		0 V DC
DC output (12 V)	1, 9 – red		Used to power camera	12–13.2 V DC
				Max load = 6 A

57