Axis Communications AXIS P3301 Install the hardware, Mount the camera, Mounting on a hard ceiling

AXIS P3301/-V Installation Guide Page 5

Install the hardware

!IMPORTANT! - The casing of the AXIS P3301-V is not approved for outdoor use - the product may only be installed in indoor environments.

Mount the camera

The AXIS P3301/-V can be mounted with the cables routed through the wall/ceiling, or from above or below. There are cover plates for the openings on both sides of the dome cover.

The AXIS P3301/-V can also be fitted with a metal conduit for protecting the cabling when connected via the side openings. See the illustrations on page 4.

1.Using the drill template, drill two holes in the ceiling/wall. Ensure the camera is positioned so that the tamper-proof screws can be tightened using the supplied screwdriver.

2.Route the required cables. See Connect the cables, on page 6 for details.

3.Fasten the camera unit to a ceiling or wall, using screws and plugs appropriate for the ceiling/ wall material.

4.Proceed to Connect the cables, on page 6.

Mounting on a hard ceiling

To mount the AXIS P3301/-V on a hard ceiling, check that the ceiling material is sturdy enough to hold the weight of the camera.

The camera can also be secured using a plate or board that better carries the weight of the camera, and which is more suitable for securing the screws.

Plate or board

Ceiling

AXIS P3301/-V

Screws

ENGLISH

The AXIS P3301/-V can also be mounted using the AXIS P3301/-V Drop Ceiling Mount, which allows the camera to be mounted more discreetly. Please see www.axis.com for all available mounting accessories.