Panasonic WV-NS324 operating instructions Network Connections

• Ethernet Connection

Data transmission

Data reception

Red

Orange

Yellow

Green

TX +

TX –

RX +

RX –

q

w

e

r

t

y

u

i

•ALARM IN Connections

An 8-pin and a 4-pin harness are supplied with the camera as standard accessories. Connect external sensors to this connector. Input specifications are low-active, non-voltage contact (ON when active) or open collector (Low when active). The table below shows wire colors versus pin functions.

Alarm IN (8-pin)
Wire Color	Function
Black	IN 1
Brown	GND
Red	IN 2
Orange	GND
Yellow	GND
Light Blue or Green	GND
Blue	GND
Purple	GND

•ALARM OUT/AUX OUT Connections

Connect an external device, for example, a buzzer or lamp, to this connector. Output specifications are low-active, open-collector and a drive capacity of 16 V DC 100 mA maximum. The table below shows wire colors versus pin functions.

Note: Use a relay if the voltage or current of the connected device exceeds the ratings.

Alarm OUT/AUX OUT (4-pin)

Wire Color	Function
Gray	Alarm OUT
White	GND
Pink	AUX OUT
Yellow Green or Light Blue	GND

•Video Cable Connections

The maximum extensible coaxial cable length between the camera and the monitor is shown in the table.

Type of		RG-59/U	RG-6/U	RG-11/U	RG-15/U
coaxial cable		(3C-2V)	(5C-2V)	(7C-2V)	(10C-2V)
Recommended	(m)	250	500	600	800
maximum
cable length	(ft)	825	1 650	1 980	2 640

Network Connections

Prior to connections, specify the connection type and prepare relevant devices and cables.

Notes:

•We recommend that you use connection type 1 or 2 when setting up the network address of the cam- era.

•Be sure to unplug or switch off all the devices before starting connections.

•Direct Connection to PC (Type 1)

Use a category 5 cross-type network cable to connect the camera directly with the PC.

Network Cable (Cross type)

PC

Necessaries: Cross-type network cable (Category 5)

-13-