Panasonic WV-BP330 manual Installation of Auto Iris Lens Connector

Page 13

Installation of Auto Iris Lens Connector

Install the lens connector (YFE4191J100) when using a video drive ALC lens.

The installation should be made by qualified ser- vice personnel or system installers.

(1)Cut the iris control cable at the edge of the lens connector to remove the existing lens connector and then remove the outer cable cover as shown in the diagram below.

The pin assignment of the lens connector is as fol- lows:

Pin 1: Power source; +9V DC, 50mA max.

Pin 2: Not used

Pin 3: Video signal; 1.3 V[p-p]/40 k

Pin 4: Shield, ground

Rib

Pin 3

Pin 1

Pin 4

Pin 2

(2)After connection, assemble the lens connector as follows.

Connector

CoverAutomatic

Iris Lens

Heat

Shrinkable

Tubes

Iris Control

Cable

Connector

Note: When the iris control cable is too thick to lock the connector cover with the connector base, cut off the rib on the connector.

(Set the Lens Drive Signal Selector to the VIDEO position.)

-11-

Image 13
Contents WV-BP330/WV-BP332/WV-BP334 This equipment generates and uses radio frequency energy Contents Preface FeaturesClean the CCD faceplate with care PrecautionsDo not attempt to disassemble the camera Handle the camera with careWV-BP330 Major Operating Controls and Their FunctionsFlange-back Adjusting Ring Auto Iris lens ConnectorPower Cord only WV-BP330 Lens option Camera Mounting Screw Hole2Lens Drive Signal Selector VIDEO, DC 1Back Light Compensation Mode Selector BLC4Vertical Phase Control Phase only WV-BP330 and WV-BP334 6Video Output Connector Video OUT7Gen-lock Input Connector GEN-LOCK WV-BP330 120V AC 60Hz ConnectionsWV-BP332 12V DC WV-BP334 24V AC 60Hz Recommended wire gauge sizes for 24V AC lineType RG-59/U RG-6/U RG-11/U RG-15/U Coaxial cable Installation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Mounting from the bottom Installation of CameraMounting from the top Prevention of Blooming and Smear Specifications Standard Accessories Version Française Table DES Matières Caractéristiques Dominantes PrèfaceManipuler la caméra vidéo de surveillance délicatement Mesures DE PrécautionPage Principaux Organes DE Commande ET Leurs Fonctions Bague de réglage de foyer arrière Connecteur de cordon d’objectif à diaphragme automatique2Sélecteur de signal de commande d’objectif VIDEO, DC Mesures de précaution 6Connecteur de sortie vidéo Video OUTWV-BP330 Courant alternatif 120 V, 60 Hz Branchement DE SystèmeWV-BP332 courant continu 12 WV-BP334 courant alternati 24 V,60Hz Câble vidéoType de RG-59/U RG-6/U RG-11/U RG-15/U Câble coaxial Installation de l’objectif Page Réglage DE Mise AU Point OU DE Foyer Arrière Fixation par la base Installation DE LA Caméra Vidéo DE SurveillanceFixation par le haut Mesure Préventive Contre L’HYPERLUMINOSITÉ ET LE Traînage Caractéristiques Techniques Capuchon d’objectif Connecteur d’objectif ALC YFE4191J100 Accessoires StandardPage V8QA4916EN Imprimé en Chine