Panasonic WV-BP330 manual Focus or FLANGE-BACK Adjustment

Page 15

FOCUS OR FLANGE-BACK ADJUSTMENT

The following adjustment should be made by qualified service personnel or system installers.

1.Loosen the screws on the flange-back adjusting ring.

Focus adjustment for

CS-mount lensFocus adjustment for

C-mount lens

Flange-back

Adjusting Ring

Screws

3.Tighten the screws on the flange-back adjusting ring.

Note: If the camera is connected to the Quad System, glare may appear at the edge of the camera picture on the monitor.

If this bothers you, adjust the lens focus to reduce the glare.

2.Turn the flange-back adjusting ring to the desired position.

Caution: When the C-mount lens is mounted, do not rotate the ring counterclockwise by force after it stops. If the ring is rotated by force, the inner lens or CCD image sensor may be dam- aged.

-13-

Image 15
Contents WV-BP330/WV-BP332/WV-BP334 This equipment generates and uses radio frequency energy Contents Preface FeaturesHandle the camera with care PrecautionsClean the CCD faceplate with care Do not attempt to disassemble the cameraWV-BP330 Major Operating Controls and Their FunctionsLens option Camera Mounting Screw Hole Auto Iris lens ConnectorFlange-back Adjusting Ring Power Cord only WV-BP3306Video Output Connector Video OUT 1Back Light Compensation Mode Selector BLC2Lens Drive Signal Selector VIDEO, DC 4Vertical Phase Control Phase only WV-BP330 and WV-BP3347Gen-lock Input Connector GEN-LOCK Connections WV-BP330 120V AC 60HzWV-BP332 12V DC WV-BP334 24V AC 60Hz Recommended wire gauge sizes for 24V AC lineType RG-59/U RG-6/U RG-11/U RG-15/U Coaxial cable Installation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Installation of Camera Mounting from the bottomMounting from the top Prevention of Blooming and Smear Specifications Standard Accessories Version Française Table DES Matières Caractéristiques Dominantes PrèfaceManipuler la caméra vidéo de surveillance délicatement Mesures DE PrécautionPage Principaux Organes DE Commande ET Leurs Fonctions Bague de réglage de foyer arrière Connecteur de cordon d’objectif à diaphragme automatique2Sélecteur de signal de commande d’objectif VIDEO, DC Mesures de précaution 6Connecteur de sortie vidéo Video OUTBranchement DE Système WV-BP330 Courant alternatif 120 V, 60 HzWV-BP332 courant continu 12 WV-BP334 courant alternati 24 V,60Hz Câble vidéoType de RG-59/U RG-6/U RG-11/U RG-15/U Câble coaxial Installation de l’objectif Page Réglage DE Mise AU Point OU DE Foyer Arrière Installation DE LA Caméra Vidéo DE Surveillance Fixation par la baseFixation par le haut Mesure Préventive Contre L’HYPERLUMINOSITÉ ET LE Traînage Caractéristiques Techniques Capuchon d’objectif Connecteur d’objectif ALC YFE4191J100 Accessoires StandardPage V8QA4916EN Imprimé en Chine