Panasonic manual Auto Iris lens Connector, Flange-back Adjusting Ring, Power Cord only WV-BP330

qAuto Iris lens Connector

This connector is for connecting the auto iris lens by a 4-pin male connector supplied as a standard accessory (Part No. YFE4191J100).

wFlange-back Adjusting Ring

This ring adjusts the back focal length or picture focus. Rotate this ring clockwise for a C-mount lens or counterclockwise for a CS-mount lens.

eLens (option)

rCamera Mounting Screw Hole

This hole for mounting the camera onto a mounting bracket.

tPower Cord (only WV-BP330)

Connect this power cord to an electrical outlet of 120V AC 60Hz.

yDC 12 V Input Terminal

(DC 12V IN (only WV-BP332))

This terminal is for connecting the 12V DC power supply cord.

uAC 24V Input Terminal

(AC 24V IN (only WV-BP334))

This terminal is for connecting the 24V AC 60Hz

power supply cord.

iSynchronization Mode Selector

(INT, LL (only WV-BP330 and WV-BP334)) Selects the camera synchronization mode from internal sync mode (INT) or line-lock mode (LL). INT: When no signal is supplied to the GEN-LOCK

connector, the camera synchronization mode is set to internal 2:1 interlace. Whenever the gen-lock video signal is supplied to the GEN- LOCK connector, the camera synchronization mode is automatically set to external synchro- nization.

LL:The camera synchronization mode is set to line-lock even if the gen-lock video signal is

supplied to the GEN-LOCK connector.

Note: Set this selector to INT for gen-lock opera- tion.

oAGC ON/OFF Selector (AGC ON, OFF) Selects the gain of the video amplifier as follows: AGC ON: When the lens iris is fully open under

low light conditions, a clear picture is obtained by automatic increase of the gain.

OFF: A natural and low-noise picture is obtained under low light conditions.

-5-