Scene File Setting Scene File, To turn

2.Press the PAGE button. The BLACK BAL menu (manu- al black balance setting menu) appears.

BLACK BAL
R-PED	....-	....I	+
B-PED	....-	....I	+

RET END

3.Move the cursor to R-PED. The cursor starts blinking.

4.Attach the lens cap on the camera lens.

5.While observing the vector scope or waveform monitor, adjust the red pedestal level (R-PED) for minimum car- rier by pressing A or B.

6.Move the cursor to B-PED. The cursor starts blinking.

7.While observing the vector scope or waveform monitor, adjust the blue pedestal level (B-PED) for minimum carrier by pressing A or B.

Note: To reset the pedestal level to the factory setting, move the cursor to R-PED or B-PED and press the A and B button simultaneously for a second or more. The R-PED or B-PED level value reset to the factory setting.

8.Scene File Setting (SCENE FILE)

This menu allows for you to adjust and set 16 items for the video signal of the camera to meet your requirments.

You can store two sets of values in two different scene files.

Use the Scene File Selector on the front panel of the camera control unit to select SCENE FILE 1 or SCENE

FILE 2.

1.Move the cursor to the SCENE FILE parameter and select SCENE 1.

** SET UP **

CAMERA ID	*OFF
FLD/FRM	FLD
ELC	*OFF
SHUTTER	OFF
GAIN	AUTO
SYNC	INT
BLACK BAL	ABC
SCENE FILE	*SCENE1
END

2.Press the PAGE button. The SCENE FILE menu appears.

SCENE FILE 1				P1
GAMMA		-....	I....	+
AUTO KNEE			ON
TOTAL-PED		-....	I....	+
CHROMA GAIN -....			I....	+
DTL BAND		-	.I	+
HDTL GAIN		-....	I....	+
VDTL GAIN		-....	I....	+
RED DTL			OFF
NEXT	RET	END
SCENE FILE 1				P2
CLEAN DNR
			OFF
2D LPF			OFF
MATRIX R-G		-....	I....	+
MATRIX R-B		-....	I....	+
MATRIX G-R		-....	I....	+
MATRIX G-B		-....	I....	+
MATRIX B-R		-....	I....	+
MATRIX B-G		-....	I....	+
HUE		-....	I....	+
NEXT	RET	END

There are 2 pages for SCENE FILE (P1 and P2). On page 1 (P1), you can set the following items:

•Gamma Correction (GAMMA)

•Auto Knee ON/OFF (AUTO KNEE)

•Total Pedestal Level Control (TOTAL-PED)

•Chrominance Level Control (CHROMA GAIN)

•Detail Band Control (DTL BAND)

•Horizontal Detail Gain Control (HDTL GAIN)

•Vertical Detail Gain Control (VDTL GAIN)

On page 2 (P2), you can set the following items:

•Red Detail ON/OFF (RED DTL)

•Clear Digital Noise Reduction Control (CLEAN DNR)

•2 Dimention Low Pass Filter (2D LPF)

•6 Chroma Matrix Controls (MATRIX R-G)

(MATRIX R-B) (MATRIX G-R) (MATRIX G-B) (MATRIX B-R) (MATRIX B-G)

•Chroma Phase Control (HUE)

To turn the page

Move the cursor to NEXT and press the PAGE button.

Returning to the SETUP menu

Move the cursor to RET and press the PAGE button.