Panasonic GP-US532HA, GP-US522HA operating instructions Specifications

Page 23

SPECIFICATIONS

Pick-up System:

Micro prism system

Image Sensor:

Three 1/2" interline transfer (IT) super high sensitivity CCDs (GP-US522)

 

Three 1/3" interline transfer (IT) super high sensitivity CCDs (GP-US532)

Pixels:

768 (Horizontal) x 494 (Vertical)

Scanning Standard:

525 lines, 60 fields, 30 frames

Synchronizing System:

Internal or External (Gen-Lock), automatically switchable

Internal:

EIA standard

 

External (Gen-Lock) Input: VBS/VS/HD/VD is selectable

 

 

SC Phase for Gen-Lock (VBS): Free adjustable over 360°

 

 

H Phase for Gen-Lock (VS): Adjustable

Video Outputs:

Video Output: BNC Connector x 2

 

1.0V[p-p] NTSC composite/75

 

Y/C (S-VIDEO) Output: S-VIDEO Connector x 1

 

0.714V[p-p] Luminance level (Y)/75 (S-VIDEO connector)

 

0.286V[p-p] Burst Level (C)/75 (S-VIDEO connector)

 

RGB/SYNC Output: D-SUB 9-pin Connector x 1

 

R/G/B:

0.7V[p-p] each/75

 

SYNC:

4V[p-p]/75 or 0.3V[p-p]/75 selectable

 

VIDEO:

NTSC composite/75

Required Illumination:

2000 lx at F11.0, 3200 K (GP-US522)

 

2000 lx at F8.0, 3200 K (GP-US532)

Minimum Illumination:

5 lx (0.5 foot candle) at F2.8 with +18 dB gain, 30 IRE level (GP-US522)

 

9 lx (0.9 foot candle) at F2.2 with +18 dB gain, 30 IRE level (GP-US532)

Signal-to-Noise Ratio:

62 dB (Typical, Luminance) without aperture and gamma

Horizontal Resolution:

800 lines at center (Y signal) (GP-US522)

 

750 lines at center (Y signal) (GP-US532)

White Balance:

ATW (Automatic Tracing White Balance Control), AWC (Automatic White

 

Balance Control) and Manual

Black Balance:

ABC (Automatic Black Balance) and Manual

Color Bar:

SMPTE color bar with 7.5% set-up

Electronic Shutter:

AUTO:

Adjustable between 1/60 - 1/10 000s

 

STEP:

Selectable 1/60(OFF),1/100, 1/250, 1/500, 1/1 000, 1/2 000,

 

 

1/4 000 and 1/10 000s

 

SYNCHRO SCAN: Selectable from 1/525 to 254/525 line

Gain Selection:

AGC and Gain Up (Selectable)

Switches:

Power On/Off (POWER), Camera/Color Bar Selection (CAM/BAR),

 

Gain Up Selection (OFF/LOW/HIGH (0/+9/+18 dB)), White Balance Selection

 

(ATW/AWC/MANU), ELC (Electronic Light Control) On/Off, PAGE, ITEM (AWC),

 

A (ABC) and B

Controls:

R Gain, B Gain and ELC LEVEL

Computer Interface

RS-232C : D-SUB 9-pin Connector x 1

Lens Mount:

Special C Mount (GP-US522)

 

C Mount (GP-US532)

Power Source:

12 V DC

 

Power Consumption:

8.4 W

 

Ambient Operating Temperature:

32°F - 113°F (0°C - +45°C)

Ambient Operating Humidity:

30 % - 90 %

Dimensions

 

 

Camera Head:

34 (W) x 44 (H) x 52 (D) mm

(Excluding Mounting Adaptor)

[1-5/16" (W) x 1-11/16" (H) x 2" (D)]

CCU:

206.5 (W) x 44 (H) x 250 (D) mm

(Excluding Rubber Foot and Connector) [8-1/8" (W) x 1-11/16" (H) x 9-1/2" (D)]

Weights

 

 

Camera Head:

110 g (0.24 lbs)

CCU:

1.7 kg (3.74 lbs)

Dimensions and Weights indicated are approximate

Specifications are subject to change without notice

23

Image 23
Contents GP-US532HA Contents Preface FeaturesAsk a qualified service person for installation PrecautionsClean the faceplate with care Put the lens cap on the camera after using the cameraCamera Mounting Screw Hole Camera Cable ConnectorPower Indicator Power Lens MountWhite Balance Selector ATW/AWC/MANU Auto Warning IndicatorTitle Input Connector Title Camera/Color Bar Selector CAM/BARGen-Lock Signal Input Connector VD Camera Cable Connector CameraGen-lock Signal Input Connector VBS/HD External HD and VD ModeDC Input Terminals 12V DC Video Output Connector S-VIDEO OUTRGB/SYNC Output Connector RGB/SYNC RS-232C Connector RS-232CInternal Sync Operation ConnectionsLens Mount Mounting the LensLeft Button a SetupItem Button Item This button is used to move the cursor downwardsPress the page button for a few seconds Opening the Setup menuEditing the Setup menu All Reset OperationCamera Identification Camera ID Setting ProceduresField/Frame Charging Mode Setting FLD/FRM ELC detection control area setting ELC Electronic Light Control Setting ELCPeak and Average Weight Control PEAK/AVE Manual setting of the ELC detection control area ManuAGC detection control area setting AGC Electronic Shutter Speed Setting ShutterGain Control Setting Gain Maximum +9 dB Synchronization Setting SyncInternal Sync Mode INT VBS Gen-lock Mode ExtvbsVS Gen-lock Mode Extvs Horizontal Phase Adjustment H PhaseSubcarrier Coarse Phase Adjustment SC Coarse Subcarrier Fine Phase Adjustment SC FineAuto Black Balance Setting Black BAL Black Balance Setting Black BALExternal HD/VD Mode HD/VD External VD Mode VDTo turn Scene File Setting Scene FileReturning to the Setup menu Gamma Correction Gamma Clear Digital Noise Reduction Control Clean DNRChroma Phase Control HUE To reset to the factory settingPrevention of Blooming and Smear Specifications Division of Matsushita Electric Corporation of America Optional AccessoriesGP-CA522/4 Character Generators