Panasonic GP-US532HA Camera Cable Connector Camera, Rear Panel, External HD and VD Mode

19.Camera Cable Connector (CAMERA)

This 20-pin connector is used for connection with the camera head via the optional camera cable GP- CA522/4.

Fasten the camera cable to this connector firmly. If not, noise may be appeared.

Caution

Connecting or disconnecting the camera cable to/from the camera control unit or camera head must be done after turning off the Power of the camera control unit.

For Camera					For CCU
						1
	24		23		2	5
22	21	20	19	18	6	10
17	16	15	14	13	11	15
12	11	10	9	8
7	6	5	4	3	16	19
	2		1			20

[Rear Panel]

	Camera Head Side
1	+15V Input
2	Ground (GND)
3	Chip Select Input
4	+25 Input
5	− 9V Input
6	B Signal Output
7	RGB Ground (GND)
8	Serial Data Input
9	Serial Clock Input
10	CCD Select Output
11	G Signal Output
12	R Signal Output
13	VD Input
14	CPOB Output
15	HD Input
16	+9V Input
17	+5V Input
18	PBLK Output
19	Not used
20	Not used
21	Not used
22	Not used
23	28MHz Input
24	Not used

Camera Control Unit Side

1	Ground (GND)
2	Not used
3	PBLK Input
4	+9V Output
5	− 9V Output
6	28MHz Output
7	CPOB Input
8	RGB Ground (GND)
9	+5V Output
10	B Signal Input
11	Serial Clock Output
12	VD Output
13	Chip Select Output
14	+25 Output
15	R Signal Input
16	Serial Data Output
17	HD Output
18	G Signal Input
19	+15V Output
20	CCD Select Input

VBS/HD	VD	75Ω	S-VIDEO	DC 12V IN
		ON	OUT	RS-232C
		OFF	1	VIDEO 2

RGB/SYNC

20.Gen-lock Signal Input Connector (VBS/HD)

The color video signal of the camera is automatically synchronized with the gen-lock signal (Composite Signal, Black Burst Signal or Video Sync) when either signal is supplied to this connector.

The gen-lock signal is used for system reference.

Caution :

If the gen-lock signal is jittery (as in the case of a VCR playback picture), the camera cannot be syn- chronized properly.

(External HD and VD Mode)

The horizontal and vertical pulse of the color video signal is synchronized with the external HD fed to this connector and external VD fed to the VD input connector.

21.Gen-Lock Signal Input Connector (VD)

Supply the external vertical drive (VD) pulse to this connector.

22.Gen-Lock Video 75 Ω Termination ON/OFF Switch (75 Ω ON/OFF)

When looping through the gen-lock video signal with a BNC "T" adapter, set this switch to OFF. When not looping through, set this switch to ON.

23.Video Output Connector (VIDEO 1,2)

A 1.0V[p-p]/75 Ω composite video signal is provided at this connector.

7