Classe Audio SSP-800 owner manual Max volume Startup volume IR setup

Page 38

max volume

startup volume

IR setup

38

The Max Volume page allows you to establish a maximum volume setting for your system. This scale runs from 0 to 100, with 100 indicating that you do not want any artiﬁcial limit placed on the maximum gain your Surround Sound Processor can provide. This setting is interactive. You can set the value to something less than 100, and then adjust the volume to see whether it is appropriate.

NOTE: The volume knob itself does not set the maximum volume; you must set the maximum volume level in this Max Volume setup menu.

Touching the Startup Volume option allows you to set up a preferred volume level for when the SSP-800 wakes out of standby. This starting volume level can be conﬁgured in two ways:

•the Last Volume option sets the starting volume to the last level selected before the unit was powered down. The mute setting is also remembered.

•the Speciﬁc option allows you to set a speciﬁc volume level with the mute control on or oﬀ.

Touching the IR option displays the IR volume speed setup page, shown below. Similar to the rotary knob setup, the IR volume speed controls the degree at which the volume is stepped through when the remote control volume button is pressed. Three settings are available – Fast, Normal, and Slow. The default setting is Normal.

Image 38

Contents SSP-800 Surround Sound Processor Page Important Safety Instructions Contents Configuration Use Video Next input Introduction Welcome to the Classé familyExceptional Design Features Page Unpacking and Placement Unpacking your SSP-800Placement considerations Warm-up/break-in period Operating voltage Voltage protection Front Panel Standby/On SwitchMenu On/Off Switch Audio Mute Control Volume Control KnobTouchscreen IR windowRear Panel Video InputsHdmi Inputs Composite Video InputsComponent Video Inputs Digital Audio Inputs Coaxial Hdmi OutputsComponent Video Output Digital Audio Inputs Optical11 7.1-Channel Analog Audio Inputs Digital Audio Output CoaxialDigital Audio Output Optical 12 2-Channel Balanced Analog Audio InputsTrigger Outputs IR InputIR Output USB Port 18 RS-232 PortCAN-Bus Input and Output 20 10-Channel Analog OutputsMain Power On/Off Switch AC Power Cord InputAudio Processing Functions Remote ControlBasic Functions Input Sel Selection ButtonNavigation & Menu Buttons Preset Config Configuration ButtonVolume Control & Mute Buttons Function Keys F1 to F4Choose the appropriate cables Initial SetupStep Connect all source components to the SSP-800 rear panel Terminals to black terminals Power up the system Understanding Surround Sound Name Post-processing DTS-HDUsing the SSP-800 Source selectionMode selection Name DescriptionData in the soundtrack Controls System trimsConfiguration select Menu System System setup Volume setupMax volume Startup volume IR setup Automation Mute setup Input setup NameAudio Configuration Use Video Next input TriggersProfiles Room EQ Configuration Name Distances Levels Use SpeakersSpeakers available Auxiliary channels Black level Teach IRDisplay setup Brightness TimeoutLanguage OSD on screen display Colors Volume Dolby/DTS Dolby Pro Logic DTS Neo6Remote Fkeys Important note on Fkey useFeatures Version info SensorsCategory 5 Network Cables Hardware setupClassé Delta Series Products CAN-Bus Terminator SSP-300 & 600 CAN-Bus Interface BoxUsing CAN-Bus CAN-Bus shared features Configuration Operate AC status StatusPlayLink Amp info Event log There is no sound and the Standby LED is not lit TroubleshootingEverything appears to be powered on, but there is no sound There is a hum coming out of the speakers IR remote control does not seem to functionOnly one speaker seems to be playing There is a hum coming from the SSP-800Voltage Protection Circuit Care & Maintenance Input factory defaultsNet weight SpecificationsOverall dimensions Shipping weightDimensions Installation Worksheet Page North America 1 800 370 3740 email classe@bwgroupusa.com