Classe Audio SSP-800 owner manual Power up the system

Page 27

Step 6

Power up the system!

Now you are ready to power up your SSP-800 and your surround system.

•Turn the rear panel power switch of the SSP-800 to ON.

•The initial power-up cycle of the SSP-800 takes approximately 90 seconds. During this time, the blue LED on the standby button ﬂashes.

•When the power-up cycle is complete, the SSP-800 enters Standby mode. The LED stops ﬂashing but remains illuminated, indicating that the SSP-800 is in Standby mode. Refer to the Front Panel section, for more details about Standby mode.

•Press the Standby button or the front panel touchscreen to bring the SSP-800 to its fully ON mode. The front panel touch screen displays a blue screen with an “initializing” message and then switches to the home page of the menu system. Refer to the Menu System section found later in the manual for more information.

The physical setup of the SSP-800 and system components is complete.

27

Image 27

Contents SSP-800 Surround Sound Processor Page Important Safety Instructions Contents Configuration Use Video Next input Welcome to the Classé family IntroductionExceptional Design Features Page Unpacking your SSP-800 Unpacking and PlacementPlacement considerations Warm-up/break-in period Operating voltage Voltage protection Standby/On Switch Menu On/Off SwitchFront Panel IR window Volume Control KnobTouchscreen Audio Mute ControlVideo Inputs Rear PanelComposite Video Inputs Component Video InputsHdmi Inputs Digital Audio Inputs Optical Hdmi OutputsComponent Video Output Digital Audio Inputs Coaxial12 2-Channel Balanced Analog Audio Inputs Digital Audio Output CoaxialDigital Audio Output Optical 11 7.1-Channel Analog Audio InputsUSB Port 18 RS-232 Port IR InputIR Output Trigger Outputs20 10-Channel Analog Outputs CAN-Bus Input and OutputAC Power Cord Input Main Power On/Off SwitchInput Sel Selection Button Remote ControlBasic Functions Audio Processing FunctionsFunction Keys F1 to F4 Preset Config Configuration ButtonVolume Control & Mute Buttons Navigation & Menu ButtonsInitial Setup StepChoose the appropriate cables Connect all source components to the SSP-800 rear panel Terminals to black terminals Power up the system Understanding Surround Sound Name DTS-HD Post-processingSource selection Using the SSP-800Name Description Mode selectionData in the soundtrack System trims ControlsConfiguration select Menu System Volume setup System setupMax volume Startup volume IR setup Automation Mute setup Name Input setupAudio Configuration Triggers Use Video Next inputProfiles Room EQ Configuration Name Distances Use Speakers LevelsSpeakers available Auxiliary channels Teach IR Black levelBrightness Timeout Display setupLanguage OSD on screen display Colors Volume Dolby Pro Logic DTS Neo6 Dolby/DTSImportant note on Fkey use Remote FkeysVersion info Sensors FeaturesCAN-Bus Terminator SSP-300 & 600 CAN-Bus Interface Box Hardware setupClassé Delta Series Products Category 5 Network CablesUsing CAN-Bus Configuration Operate AC status Status CAN-Bus shared featuresPlayLink Amp info Event log Troubleshooting Everything appears to be powered on, but there is no soundThere is no sound and the Standby LED is not lit There is a hum coming from the SSP-800 IR remote control does not seem to functionOnly one speaker seems to be playing There is a hum coming out of the speakersVoltage Protection Circuit Input factory defaults Care & MaintenanceShipping weight SpecificationsOverall dimensions Net weightDimensions Installation Worksheet Page North America 1 800 370 3740 email classe@bwgroupusa.com