Kenwood TM-V71E, TM-V71A instruction manual Memory Scan, Locking Out a Memory Channel, Press MR 1s

MEMORY SCAN

Use Memory Scan to monitor all Memory channels programmed with frequency data.

1Select your desired band.

2Press [MR] (1s).

•Scan starts at the current frequency.

•The 1 MHz decimal blinks while scanning is in progress.

•To reverse the scan direction, turn the Tuning control clockwise (upward scan) or counterclockwise (downward scan). You can also press microphone [UP]/ [DWN].

3To quit Memory Scan, press [MR] again.

Note:

uAt least 2 Memory channels must contain data and must not be locked out of scan.

uThe L0/U0 to L9/U9 Memory channels will not be scanned.

uYou can also start Memory Scan when in Channel Display mode. While Scan is paused on a channel, the channel number blinks.

nLocking Out a Memory Channel

You can select Memory channels that you prefer not to monitor while scanning. 1 Press [MR], then rotate the Tuning control to select your desired channel. 2 Enter Menu mode and access Menu 202 (L.OUT) {page 20}.

3 Set the lockout to ON to lock the channel out of the scanning sequence.

•To cancel lockout, set the lockout to OFF.

•The icon appears on the display for a channel that has been locked out.

Note: The L0/U0 to L9/U9 Memory channels cannot be locked out.

44