Kenwood TM-V71E, TM-V71A instruction manual Key Beep, Programmable VFO, Beep Volume

Key Beep

You can turn the transceiver beep function ON or OFF as desired.

1Enter Menu mode and access Menu 000 (BEEP) {page 20}.

2Turn the beep function ON or OFF.

•Even with the beep function turned OFF, the transceiver will emit a beep tone under the following conditions:

1)When Auto Power Off is activated, the transceiver will beep 1 minute before the power turns off.

2)After transmitting for the maximum time duration according to the Time-out Timer, the transceiver will beep

nBeep Volume

Each time you press a key, the beep tone will sound. If you have left the beep function turned ON, you may wish to adjust the volume level of the beep.

1 Enter Menu mode and access Menu 001 (BP.VOL) {page 20}.

2Set the beep volume to a level from 1 to 7.

• The default is level 5.

Programmable VFO

If you always check frequencies within a certain range, you can set upper and lower limits for frequencies that are selectable. For example, if you select 144 MHz for the lower limit and 145 MHz for the upper limit, the tunable range will be from 145.000 MHz to 146.995 MHz.

1Press the left or right [BAND SEL] to set band A or B as the operating band, then press [VFO].

2Enter Menu mode and access Menu 100 (PRG.VFO) {page 20}. (Example: E type)

64