Black plate (16,1)
Section
04 Tuner
Listening to the radio
1 2 | 3 4 | 5 |
6
These are the basic steps necessary to operate the radio. More advanced tuner operation is explained starting on the next page.
Important
If you are using this unit in North, Central or South America, reset the AM tuning step (see Setting the AM tuning step on page 84).
1Stereo (5) indicator
Shows when the selected frequency is being broadcast in stereo.
2LOC indicator
Shows when local seek tuning is on.
3Band indicator
Shows which band the radio is tuned to, AM or FM.
4Preset number indicator
Shows which preset has been selected.
5Frequency indicator
Shows the frequency to which the tuner is tuned.
6Signal level indicator Shows the radio wave strength.
1Press SOURCE to select the tuner. Press SOURCE until you see Tuner displayed.
2 Press BAND to select a band.
Press BAND until the desired band
3To perform manual tuning, push
The frequencies move up or down step by step.
4To perform seek tuning, push and hold
The tuner will scan the frequencies until a broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
# If you push and hold
right you can skip stations. Seek tuning starts as soon as you release
16 En