Pioneer DEH-P9850BT operation manual Before operating the auto TA and EQ function

Page 80

Black plate (80,1)

Section

13 Audio Adjustments

Auto TA and EQ (auto-time alignment and auto- equalizing)

The auto-time alignment is automatically ad- justed for the distance between each speaker and the listening position.

The auto-equalizer automatically measures the car interior acoustic characteristics, and then creates the auto-equalizer curve based on that information.

WARNING

To prevent accidents, never carry out auto TA and EQ while driving. When this function measures the car interior acoustic characteristics to create an auto-equalizer curve, a loud measurement tone (noise) may be outputted from the speakers.

CAUTION

!Carrying out auto TA and EQ under the follow- ing conditions may damage the speakers. Be sure to check the conditions thoroughly be- fore carrying out auto TA and EQ.

—When speakers are incorrectly connected. (e.g., When a rear speaker is connected to a subwoofer output.)

—When a speaker is connected to a power amp delivering output higher than the speaker’s maximum input power capabil- ity.

!If the microphone is placed in an unsuitable position the measurement tone may become loud and measurement may take a long time, resulting in a drain on battery power. Be sure to place the microphone in the specified loca- tion.

80 En

Before operating the auto TA and EQ function

!Carry out auto TA and EQ in as quiet a place as possible, with the car engine and air conditioning switched off. Also cut power to car phones or portable telephones in the car, or remove them from the car be- fore carrying out auto TA and EQ. Sounds other than the measurement tone (sur- rounding sounds, engine sound, tele- phones ringing etc.) may prevent correct measurement of the car interior acoustic characteristics.

!Be sure to carry out auto TA and EQ using the supplied microphone. Using another microphone may prevent measurement, or result in incorrect measurement of the car interior acoustic characteristics.

!When front speaker is not connected, auto TA and EQ cannot be carried out.

!When muting the front speaker units, auto TA and EQ cannot be carried out. (Refer to page 75.)

!When this unit is connected to a power amp with input level control, auto TA and EQ may not be possible if you lower power amp input level. Set the power amp’s input level to the standard position.

!When this unit is connected to a power amp with an LPF, turn off the LPF on the power amp before carrying out auto TA and EQ. In addition, the cut-off frequency for built-in LPF of an active subwoofer should be set to the highest frequency.

!The time alignment value calculated by auto TA and EQ may differ from the actual distance in the following circumstances. However, the distance has been calculated by computer to be the optimum delay to give accurate results for the circum- stances, so please continue to use this value.

—When the reflected sound within a vehi- cle is strong and delays occur.

<CRB2179-A/N>80

Page 79 Page 81
Image 80
Page 79 Page 81
Contents DEH-P9850BT Contents Thank you for buying this Pioneer productReading jacket arts Multi-CD Player Playing a CD Adjusting source levels Features Before You Start About this unitAbout this manual Operating environmentAbout Bluetooth Before You StartAbout WMA About AACProtecting your unit from theft Resetting the microprocessorClearing all memory About the demo mode Reverse modeRemoving the front panel Attaching the front panelUse and care of the remote control Feature demo modeInstalling the battery Using the remote controlAudio button operation Head unit Remote controlWhat’s What Ak e j Loading a disc Basic Operations Turning the unit onSelecting a source Turning the unit off Adjusting the volumeBasic Operations Tuner Listening to the radio Tuner Introduction of advanced tuner operation Storing and recallingBroadcast frequencies Storing the strongest broadcast frequenciesTuner Selecting stations from the preset channel listTuning in strong signals Built-in CD Player Playing a CD Selecting a track directlyRepeating play Playing tracks in random orderPausing CD playback Built-in CD Player Scanning tracks of a CDSelecting the search method Searching every 10 tracks in the current discEntering disc titles Using disc title functionsBuilt-in CD Player Using CD Text functions Displaying disc titlesDisplaying text information on CD Text discs Selecting tracks from the track title list06 MP3/WMA/AAC/WAV Player Playing MP3/WMA/AAC WAV files MP3/WMA/AAC/WAV Player Selecting a track directly in the current folderCRB2179-A/N26 Pausing MP3/WMA/AAC Scanning folders and tracksWAV playback Searching every 10 tracks in the current folderWhen playing back a WAV disc When playing back an MP3/ WMA/AAC disc06 MP3/WMA/AAC/WAV Player Displaying text information on MP3/WMA/AAC/WAV discSelecting tracks from the file name list Displaying jacket arts onCD-ROM discs Reading jacket artsSelecting folders with jacket arts 12 3 Bluetooth Telephone Setting up for hands-free phoningStandby mode About the telephone sourceBluetooth Telephone Basic operation of hands- free phoning Making a phone callTaking a phone call Answering an incoming callConnecting a cellular phone Using a cellular phone to initiate a connection Searching for available cellular phonesDeleting a registered phone Disconnecting a cellular phoneRegistering connected cellular phone Connecting to a registered phone automatically Connecting to a registered cellular phoneConnecting to a registered phone manually Using the Phone Book Transferring entries to the Phone BookAssign genres to phone numbers Changing the Phone Book display orderCalling a number in the Phone Book Editing the name of a Phone Book entry Editing phone numbers Selecting the icon of a Phone Book entryClearing a Phone Book entry Using preset numbersClearing memory Using the Call History Displaying the Call HistoryCalling a number from the Call History Assigning preset numbersMaking a call by entering phone number Echo canceling and noise reduction Changing the ring toneBluetooth Telephone Setting the automatic rejecting Setting the automatic answeringDisplaying BD Bluetooth Device address Selecting the icon for userDisplaying BD address of this unit Displaying system version for repairDisplaying BD address of your cellular phone Setting up for Bluetooth audio player Bluetooth Audio Connecting a Bluetooth audio playerBluetooth Audio Function operation Playing songs on Bluetooth audio playerPausing a song Stopping playbackDisconnecting a Bluetooth audio player Displaying BD address of this unitMulti-CD Player Playing a CD Introduction of advanced multi-CD player operation Multi-CD PlayerDisc multi-CD player Scanning CDs and tracks Playback from your ITS playlist Using ITS playlistsCreating a playlist with ITS programming Erasing a track from your ITS playlist Erasing a CD from your ITS playlistSelecting discs from the disc title list Black plate 59,1 Playing songs on iPod Listening to songs on your iPod Browsing for a songPlaying songs on iPod Displaying text information on iPodSearching for a song Selecting a playlistPlaying songs in a random order shuffle Playing songs on iPod Pausing a song TV tuner Watching the television MULTI-CONTROL left or rightStoring the strongest broadcast stations sequentially TV tuner Introduction of advanced TV tuner operationStoring and recalling broadcast stations TV tuner Selecting a folder DVD Player Playing a discSelecting a disc DVD Player Introduction of advanced DVD player operation DVD Player Pausing disc playbackUsing ITS playlist and disc title functions CRB2179-A/N70 Audio Adjustments Adjusting the audio easily Adjusting the audio finelyAdjustments Extra functionsUsing balance adjustment Audio AdjustmentsUsing the position selector Using the time alignment Adjusting the time alignmentAdjusting low pass filter attenuation slope Using subwoofer outputAdjusting subwoofer settings Muting the speaker units filters Using the high pass filterSetting the high pass filter for front speakers Using the auto-equalizer Using the equalizerSetting the high pass filter for rear speakers Recalling equalizer curvesAdjusting equalizer curves Adjusting 16-band graphic equalizerUsing BBE sound Using compression and BMXUsing auditory user interface Adjusting loudnessAdjusting source levels Before operating the auto TA and EQ function Carrying out auto TA and EQ CRB2179-A/N82 Selecting the display language Initial Settings Adjusting initial settingsSetting the date Initial Settings Setting the clockSetting the FM tuning step Setting the AM tuning stepSwitching the warning tone Switching the face auto openSwitching the auxiliary setting Switching the dimmer settingCorrecting distorted sound Switching the sound muting/attenuationSwitching the feature demo Initial Settings Switching the reverse mode Switching the Ever ScrollCalibrating the RPMs Activating the BT Audio sourceEntering PIN code for Bluetooth wireless connection Resetting the Bluetooth wireless technology moduleUsing the AUX source Setting the AUX titleOther Functions Turning the clock display on or off About AUX1 and AUX2Other Functions Using different entertainment displaysSetting the entertainment display Setting the background display EntertainmentOn rewriting the entertainment displays on CRB2179-A/N92 Understanding auto TA EQ error messages Message Cause ActionCD player and care CD-R/CD-RW discsMP3, WMA, AAC and WAV files Additional InformationDual Discs AAC additional information MP3 additional informationWMA additional information About folders and MP3/ WMA/AAC/WAV files WAV additional informationCRB2179-A/N98 Additional Information Terms A2DP100 En Additional Information Specifications General102 En CRB2179-A/N103 Pioneer Corporation
Top Page Image Contents