Pioneer DEH-P9850BT operation manual Carrying out auto TA and EQ

Page 81

Audio Adjustments

When delays occur for low sounds due to the influence of the LPF on active subwoofers or external amps.

!Auto TA and EQ changes the audio settings as below:

The fader/balance settings return to the center position. (Refer to page 72.)

The graphic equalizer curve switches to Flat. (Refer to page 76.)

When a subwoofer is connected to this unit, it will be adjusted automatically to both subwoofer output and high pass fil- ter setting for rear speaker.

!If you carry out auto TA and EQ when a pre- vious setting of this already exists, the set- ting will be replaced.

Carrying out auto TA and EQ

CAUTION

Never use the microphone for hands-free phon- ing to operate the auto TA and EQ. Using the mi- crophone unfit for the auto TA and EQ may damage the speaker. Be sure to connect the AUTO TA&EQ microphone into the microphone input jack.

1Stop the car in a place that is as quiet as possible, close all doors, windows and the sun roof, and then turn the engine off. If the engine is left running, engine noise may prevent correct auto TA and EQ.

2Fix the supplied microphone in the cen- ter of the headrest of the driver’s seat, fa- cing forward, using the belt (sold separately).

The auto TA and EQ may differ depending on where you place the microphone. If desired, place the microphone on the front passenger seat to carry out auto TA and EQ.

Black plate (81,1)

Section

13

English

3Turn the ignition switch to ON or ACC. If the car’s air conditioner or heater is turned on, turn it off. Noise from the fan in the air conditioner or heater may prevent correct auto

TA and EQ.

# Press SOURCE to turn the source on if this unit is turned off.

4Select the position for the seat on which the microphone is placed.

Refer to Using the position selector on page

# If no position is selected before you start auto TA and EQ, Front Left is selected automatically.

5Press SOURCE and hold until the unit turns off.

If anything is connected to the microphone input jack, disconnect it.

6Press and hold EQ to enter the auto TA and EQ measurement mode.

7Plug the microphone into the micro- phone input jack on this unit.

AUTO TA&EQ microphone

En 81

<CRB2179-A/N>81

Image 81
Contents DEH-P9850BT Thank you for buying this Pioneer product ContentsReading jacket arts Multi-CD Player Playing a CD Adjusting source levels Before You Start About this unit FeaturesAbout this manual Operating environmentBefore You Start About BluetoothAbout WMA About AACResetting the microprocessor Clearing all memoryProtecting your unit from theft Reverse mode About the demo modeRemoving the front panel Attaching the front panelFeature demo mode Use and care of the remote controlInstalling the battery Using the remote controlAudio button operation Remote control What’s WhatHead unit Ak e j Basic Operations Turning the unit on Selecting a sourceLoading a disc Adjusting the volume Basic OperationsTurning the unit off Tuner Listening to the radio Storing and recalling Tuner Introduction of advanced tuner operationBroadcast frequencies Storing the strongest broadcast frequenciesSelecting stations from the preset channel list Tuning in strong signalsTuner Selecting a track directly Built-in CD Player Playing a CDPlaying tracks in random order Repeating playBuilt-in CD Player Scanning tracks of a CD Pausing CD playbackSelecting the search method Searching every 10 tracks in the current discUsing disc title functions Built-in CD PlayerEntering disc titles Displaying disc titles Using CD Text functionsDisplaying text information on CD Text discs Selecting tracks from the track title list06 MP3/WMA/AAC/WAV Player Playing MP3/WMA/AAC WAV files Selecting a track directly in the current folder MP3/WMA/AAC/WAV PlayerCRB2179-A/N26 Scanning folders and tracks Pausing MP3/WMA/AACWAV playback Searching every 10 tracks in the current folderWhen playing back an MP3/ WMA/AAC disc When playing back a WAV disc06 MP3/WMA/AAC/WAV Player Displaying text information on MP3/WMA/AAC/WAV discDisplaying jacket arts on Selecting tracks from the file name listCD-ROM discs Reading jacket artsSelecting folders with jacket arts 12 3 Setting up for hands-free phoning Bluetooth TelephoneStandby mode About the telephone sourceMaking a phone call Bluetooth Telephone Basic operation of hands- free phoningAnswering an incoming call Taking a phone callConnecting a cellular phone Searching for available cellular phones Using a cellular phone to initiate a connectionDisconnecting a cellular phone Registering connected cellular phoneDeleting a registered phone Connecting to a registered cellular phone Connecting to a registered phone manuallyConnecting to a registered phone automatically Transferring entries to the Phone Book Using the Phone BookChanging the Phone Book display order Calling a number in the Phone BookAssign genres to phone numbers Editing the name of a Phone Book entry Selecting the icon of a Phone Book entry Editing phone numbersUsing preset numbers Clearing memoryClearing a Phone Book entry Displaying the Call History Using the Call HistoryAssigning preset numbers Making a call by entering phone numberCalling a number from the Call History Changing the ring tone Echo canceling and noise reductionSetting the automatic answering Bluetooth Telephone Setting the automatic rejectingDisplaying BD Bluetooth Device address Selecting the icon for userDisplaying system version for repair Displaying BD address of your cellular phoneDisplaying BD address of this unit Setting up for Bluetooth audio player Connecting a Bluetooth audio player Bluetooth AudioPlaying songs on Bluetooth audio player Bluetooth Audio Function operationPausing a song Stopping playbackDisplaying BD address of this unit Disconnecting a Bluetooth audio playerMulti-CD Player Playing a CD Multi-CD Player Disc multi-CD playerIntroduction of advanced multi-CD player operation Scanning CDs and tracks Using ITS playlists Creating a playlist with ITS programmingPlayback from your ITS playlist Erasing a CD from your ITS playlist Erasing a track from your ITS playlistSelecting discs from the disc title list Black plate 59,1 Browsing for a song Playing songs on iPod Listening to songs on your iPodDisplaying text information on iPod Playing songs on iPodSearching for a song Selecting a playlistPlaying songs in a random order shuffle Playing songs on iPod Pausing a song MULTI-CONTROL left or right TV tuner Watching the televisionTV tuner Introduction of advanced TV tuner operation Storing and recalling broadcast stationsStoring the strongest broadcast stations sequentially TV tuner DVD Player Playing a disc Selecting a discSelecting a folder DVD Player Introduction of advanced DVD player operation Pausing disc playback Using ITS playlist and disc title functionsDVD Player CRB2179-A/N70 Adjusting the audio finely Audio Adjustments Adjusting the audio easilyAdjustments Extra functionsAudio Adjustments Using the position selectorUsing balance adjustment Adjusting the time alignment Using the time alignmentUsing subwoofer output Adjusting subwoofer settingsAdjusting low pass filter attenuation slope Using the high pass filter Setting the high pass filter for front speakersMuting the speaker units filters Using the equalizer Using the auto-equalizerSetting the high pass filter for rear speakers Recalling equalizer curvesAdjusting 16-band graphic equalizer Adjusting equalizer curvesUsing compression and BMX Using BBE soundAdjusting loudness Adjusting source levelsUsing auditory user interface Before operating the auto TA and EQ function Carrying out auto TA and EQ CRB2179-A/N82 Initial Settings Adjusting initial settings Setting the dateSelecting the display language Setting the clock Initial SettingsSetting the FM tuning step Setting the AM tuning stepSwitching the face auto open Switching the warning toneSwitching the auxiliary setting Switching the dimmer settingSwitching the sound muting/attenuation Switching the feature demoCorrecting distorted sound Switching the Ever Scroll Initial Settings Switching the reverse modeCalibrating the RPMs Activating the BT Audio sourceResetting the Bluetooth wireless technology module Entering PIN code for Bluetooth wireless connectionSetting the AUX title Using the AUX sourceOther Functions Turning the clock display on or off About AUX1 and AUX2Using different entertainment displays Setting the entertainment displayOther Functions Entertainment Setting the background displayOn rewriting the entertainment displays on CRB2179-A/N92 Message Cause Action Understanding auto TA EQ error messagesCD-R/CD-RW discs CD player and careAdditional Information Dual DiscsMP3, WMA, AAC and WAV files MP3 additional information WMA additional informationAAC additional information WAV additional information About folders and MP3/ WMA/AAC/WAV filesCRB2179-A/N98 A2DP Additional Information Terms100 En General Additional Information Specifications102 En CRB2179-A/N103 Pioneer Corporation