Switching the Visual Source Only (Simultaneous Function)
You can watch the video portion of another source while listening to the current source.
•After carrying out the steps 1 to 3 of “To display the DVD mode Screen” explained on page 27, perform the operation described below.
1 Touch [VISUAL] on the audio source screen.
The VISUAL selection screen appears.
2 Touch a desired visual source.
The visual source is switched to the selected one.
Cancelling the Simultaneous Function
1 Touch the visual screen to display the main control. 2 Touch [CONTROL].
3 Touch [VISUAL] within 5 seconds.
The VISUAL selection screen appears.
4 Touch [NORMAL].
The simultaneous function is canceled.
•To make the setting, set to “Setting the VISUAL Touch Button” (page 34).
•If a DVD player is connected, you can receive the DVD picture/ sound.
DVD player
The
Press V.OUT on the remote control (included with the
•The simultaneous function cannot be used when the Audio source is in the navigation mode.
When NAV. is set in “Setting the VISUAL Touch Button” (page 34), only the navigation screen can be recalled.
Blackout Mode On and Off
When Blackout mode is turned on, the monitor display will turn off to reduce power consumption.
This additional power enhances the sound quality.
1 Touch [VISUAL] on the main source screen.
The VISUAL selection screen is displayed.
2 Touch [OFF].
The
3 Touch [OFF] again to cancel the display backlight.
•To make the setting, set to “Setting the VISUAL Touch Button” (page 34).
•If any button on the unit is pressed during Blackout mode, the function will be displayed for 5 seconds to show the operation before returning to Blackout mode.
•While the backlighting is turned off, the function indicator blinks during navigation voice interruption.
Setting VISUALIZER
This setting is available when the expansion box
1 Touch [VISUAL] on the main source screen. The VISUAL selection screen is displayed.
2 Touch [VISUALIZER].
The Visualizer setting screen is displayed. If you do not touch any button for 5 seconds, the operating display buttons, [CONTROL] etc., will disappear.
3 Touch the screen (visual screen only) after the operating display has disappeared.
The VISUALIZER setup mode is displayed.
4 Set ON/OFF by touching [ON] or [OFF] of VISUALIZER within 5 seconds.
MODE1 to
MODE6 / OFF: Recalls the maker’s setting mode on the expansion box
SCAN: Displays the pattern of MODE1 to MODE6 repeatedly.
Canceling the Visualizer Function:
Touch [NORMAL] on the VISUAL selection screen.
•To make the setting, set to “Setting the VISUAL Touch Button” (page 34).
•This setting is enabled when OFF is selected for “Setting the Visual Effect” (page 26) and ON is selected for, “Setting the VISUALIZER Mode Display” (page 34).
Setting the Visual Effect
This setting becomes available when the expansion box
1 Touch [VISUAL] on the visual main source screen. The VISUAL selection screen is displayed.
2 Touch [VISUALIZER].
The Visualizer setting screen is displayed. If you do not touch any button for 5 seconds, the operating display buttons, [CONTROL] etc., will disappear.
3 Touch the screen (visual screen only) after the operation display has disappeared.
The VISUALIZER setup screen appears.
4 Select “ON” by touching [
] or [
] of V.EFFECT within 5 seconds.
ON: Turns on the function for enhancing visual effects when connected to two or more external monitors.
Set to OFF to cancel.
•To make the setting, set to “Setting the VISUAL Touch Button” (page 34).
•V.EFFECT is not displayed when the audio main source is selected.
•When the visual effect is set to ON, the rear monitor source cannot be changed from the unit.
•This setting may not be performed while driving.