Error displays
•Mechanical error
-Press 
. After the error indication disappears, insert the disc again. If the
problem, consult your nearest ALPINE dealer.
MP3/WMA is not played back.
•Writing error occurred. The CD format is not compatible.
-Make sure the CD has been written in a supported format. Refer to “About MP3/WMA” (pages 17 and 18), then rewrite in the format supported by this device.
Unit does not operate.
•Monitor’s power is not turned on.
-Turn on the monitor’s power.
•Condensation.
-Wait a while (about 1 hour) for the condensation to dry.
No picture is produced.
•Monitor’s mode is not switched to the mode you want to see.
-Switch to the mode you want to see.
•Monitor’s parking brake lead is not connected.
-Connect the monitor’s parking brake lead and set the parking brake.
(For details, refer to the monitor’s instructions.)
•Monitor’s parking brake is not set.
-Connect the monitor’s parking brake lead and set the parking brake.
(For details, refer to the monitor’s instructions.)
Playback does not start.
•Disc is loaded
-Check the disc and load it with the labeled side facing upward.
•Disc is dirty.
-Clean the disc.
•A disc not able to playback with this unit is loaded.
-Check if the disc is able to be played back.
•Parental lock is set.
-Cancel the parental lock or change the rating level.
Picture is unclear or noisy.
•Disc is being
-The picture may be slightly disturbed, but this is normal.
•Vehicle’s battery power is weak.
-Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11 volts with a load applied.)
•Monitor’s fluorescent tube is worn.
-Replace the monitor’s fluorescent tube.
Image stops sometimes.
•Disc is scratched.
- Replaced with a
Indication for CD/MP3/WMA
•Protective circuit is activated due to high temperature.
-The indicator will disappear when the temperature returns to within operation range.
-Leave the power OFF until the temperature decreases and then turn the power ON again.
•No disc is inserted.
-Insert a disc.
•Although a disc is inserted, “NO DISC” is displayed and the unit does not start to play or eject the disc.
-Remove the disc by following these steps: Press 
for at least 3 seconds.
•Mechanism error.
1)Press 
and eject the disc.
If not ejecting, consult your Alpine dealer.
2)When the error indication remains after ejecting, press 
again.
If the error indication still does not turn off after pressing 
for a few times, consult your Alpine dealer.
•Scratched disc, contaminated disc/poor recording/disc incompatible with this unit.
- Press 
.
- Change the disc.