Alpine IVA-D310 owner manual To display the DVD mode screen, If a menu screen appears, 19-EN

Page 21

To display the DVD mode screen

To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.

1Push the foot brake to bring your vehicle to a complete stop at a safe location. Engage the parking brake.

2Keep pushing the foot brake and release the parking brake once then engage it again.

3While the parking brake is being engaged the second time, release the foot brake.

For automatic transmission vehicles, place the transmission lever in the Park position.

Now, the locking system for the DVD mode operation has been released. Engaging the parking brake can reactivate the DVD mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of “To display the DVD mode screen.”

Each time the ignition is turned OFF, perform the procedure of “To display the DVD mode screen.”

If you try to activate the auxiliary device while driving, the display will show the warning-PICTURE OFF FOR YOUR SAFETY.

Caution

Not all functions will operate for every DVD. See the individual DVD’s instructions for details on the features supported.

Fingerprints on a disc may adversely affect playback. If a problem occurs, remove the disc and check for fingerprints on the playback side. Clean the disc if necessary.

If you switch the power or Ignition Key OFF or change sources during playback, playback will continue where you left off when you resume playback.

If you try to perform an invalid operation (based on the type of disc being played), the following mark is displayed on the monitor screen:

Play Position Memory Function

Even if you turn power off or switch the Ignition Key to OFF during playback or change the source, playback will continue from the point where playback stopped when the power is turned ON again.

1Touch [SOURCE] on the main source screen. The source selection screen is displayed.

2Touch [DVD PLAYER].

The display shows the DVD player mode screen.

Insert a disc with the label side facing up. The unit starts to play the disc.

When an optional Alpine DVD player is connected: Insert a disc into the DVD/video CD/CD player, the player starts playing.

The operation screen changes to the visual screen in the DVD or video CD mode for 5 seconds after an operation has been performed. Touch the display panel to display the operation screen again.

The display mode can be changed by touching [WIDE]. For operation, see “Switching Display Modes” on page 25.

To eject the disc

Press .

The reverse side of a double-sided DVD will not be played automatically.

Remove the disc, turn it over, and reinsert it.

DO NOT insert discs containing maps for the navigation system. Doing so could result in damage.

Refer also to “DVD Setup” (pages 27 to 31).

Be sure the remote input lead is connected to the remote output lead of this unit when a DVD changer or DVD player is connected. If not correctly connected, touch operation cannot be performed.

To return to the previous screen during video CD playback, touch

[ ] after touching [P1/2] of the function guide. However, the function may vary depending on the disc.

If about 15 seconds passes without removing the disc after pressing

, the disc is automatically inserted into the unit. In this case, start playback by touching [/ ] since the unit has stopped.

If a menu screen appears

On DVDs and Video CDs with playback control (PBC), menu screens may appear automatically. If this happens, perform the operation described below to start playback.

Direct Menu Operations (DVD only)

1Touch the DVD menu directly.

Some operations cannot be performed depending on the disc.

Menu Operations (DVD only)

1Touch [KEY].

The menu operation mode will be displayed.

Touch [MENU RTN] to return to the previous display.

2Select a desired menu item by touching [], [], [ ] or [].

3Touch [ENTER] to confirm the selected item.

19-EN

Image 21
Contents IVA-D310 CHA-1214CHM-S630 CHA-S634Contents Operating Instructions Monitor Setting Navigation System Optional Installation Connections Operating Instructions Maintenance Disc Mark logo Recorded Disc size MaxVideo PicturesALL Disc terminology Location of Controls Getting StartedDetaching and Attaching the Front Panel 10-ENAdjusting the Monitor Viewing Angle Turning Power On or OffInitial System Start-Up Opening/Closing the MonitorLowering Volume Quickly Adjusting the VolumeHow to view the Display Moving the Monitor to be FlatShortcut Screen Touch a desired setup menuDisplaying the Numeric Keypad Input Screen 13-ENListening to the Radio RadioDual-Screen Display 14-ENAutomatic Memory of Station Presets Manual Storing of Station PresetsTuning to Preset Stations 15-ENRepeat Play PlaybackX. Random Play Selecting Folders concerning MP3/ WMA17-EN About MP3/WMAPlaying DVD/Video CD DVD/Video CD18-EN TerminologyIf a menu screen appears To display the DVD mode screen19-EN Direct Menu Operations DVD onlyStopping Playback PRE Stop Turning the PBC Function on or OFF Video CD onlyStopping Playback Fast-forwarding/Fast-reversingFinding the Beginnings of Chapters or Tracks Playing Still Frames PausingChapter/Track/Title Repeat Playback Forward/reverse frame-by-frame PlaybackSwitching the Angle DVD only Switching the Audio TracksSearching Directly by Chapter or Track Number 22-ENAdjusting the Audio Other Useful FeaturesSwitching from the disc menu 23-ENInternal CD player mode Touch on the function guide while in the CD or MP3/WMA modeSearch Function 24-ENSwitching the function of the remote sensor Switching Display ModesRear Entertainment Function 25-ENBlackout Mode On and Off Switching the Visual Source Only Simultaneous FunctionSetting Visualizer Setting the Visual EffectSetup Monitor SettingMonitor Setting Operation DVD Setup OperationSetting of the Audio Language Setting of the Menu LanguageSetting of the Subtitle Language Changing the Country Code SettingChanging the Digital Output Setting Setting the Rating Level Parental LockTouch the input screen to enter a new 4-digit password 29-EN30-EN 32kbps~320kbpsWindows Setting the Downmix Mode General Setup OperationSetting the TV Screen Setting Touch of General SetupSetting Daylight Saving Time Setting the TimeSetting the Scroll Setting the Sound Quality of the TunerSetting the External Device Interrupt Mode System Setup OperationSetting the Interrupt Icon Display Setting the Navigation ModeSetting the AUX Mode Setting the Visualizer Mode DisplayAdjusting the External Input Audio Level Setting of the External Monitor OutputSetting the Digital Output Display Setup OperationSetting the Brightness of the Backlighting Touch of Display SetupSwitching Background Textures Adjusting the Minimum Level of BacklightSetting Automatic Background Textures Setting the Font TypeSetting the Bass Engine Setting the MX modePersonalize 37-ENSelecting Bass Max EQ mode Maker’s setting Adjusting and Storing/Recalling the Parametric EQ38-EN Adjustment and Storing/Recalling of Time Correction About the Time Correction39-EN Adjusting and Storing/Recalling the Bass Focus Setting item Bass Focus Setting contents40-EN 41-EN Adjustment and Storing/Recalling of the Built-in CrossoverSubwoofer On and Off Visual EQ Setting OperationData Downloading Adjusting Picture QualityStoring Visual EQ 43-EN44-EN AMP Link Lock Function45-EN Adjustment Procedure for Dolby SurroundSet MX Mode of the External Audio Processor Setting the SpeakersOver Adjustment 46-ENAdjusting Level/Cut-off Frequency Directly Adjust the crossover to your preferenceCheck that Defeat mode is off Performing Time Correction Manually TCRPhase Switching Graphic Equalizer Adjustments48-EN 49-EN Parametric Equalizer AdjustmentsSpeaker Setup Setting Bass Sound ControlSetting Bass Compressor Setting Bass FocusAdjusting the DVD Level Setting of Dolby 5.1chGetting out the Preset Memory Storing Settings in the MemoryUsing the Pro Logic II Mode 52-ENSwitching the Navigation Screen Optional Linear PCM SettingNavigation System Optional 53-ENChanger Optional Auxiliary Device OptionalOperating Auxiliary Devices Optional Controlling CD Changer OptionalMulti-Changer Selection Optional HDD Player Operation OptionalListening to Music of HDD 55-ENSAT Radio Receiver Optional Tuning in to Categorized ProgramsReceiving Channels with the SAT Receiver Optional Changing the DisplayReceiving Stored Channels Storing Channel PresetsDisplaying the Category/Channel Name Title List Selecting the Channel directlySearching for a desired Song IPod OptionalSearching by Playlist Searching by artist nameAbout Subdisplay Indications About Subdisplay IndicationsRandom Play Shuffle M.I.X 59-ENRemote Control Controls on Remote Control60-EN 61-EN When Using the Remote ControlInformation Battery ReplacementAbout DVDs 62-EN63-EN TerminologyList of Language Codes 64-ENFor details, see 65-EN List of Country Codes66-EN 67-EN Case of Difficulty68-EN 69-EN Indication for DVD/Video CDIndication for CD changer 70-EN Indication for SAT Receiver Mode71-EN SpecificationsChassis Size Monitor section Chassis Size Tuner section72-EN Installation and ConnectionsInstalling the Monitor Installation Location InstallationTo install using the vehicle’s standard bracket 73-ENWhen mounting with Velcro fasteners Installing the Tuner BoxInstalling the DC/DC Converter 74-ENIf the ACC power supply is not available Connection Diagram of Spst Switch Sold Separately75-EN Parking Brake Lead Connection76-EN Connections IVA-D310 Wiring Diagram77-EN 78-EN System ExampleTo Ai-NET Connector Gray To Ai-NET Connector Black Digital Output Terminal Ai-NET Connector79-EN AUX Video Input AUX1 Terminal80-EN 81-EN To Ai-NET Connector Black To Ai-NET Connector Gray