Setup, Monitor Setting Operation | Alpine IVA-D310 guide

Monitor Setting

Monitor Setting Operation

Following Steps 1 to 4 describe the common procedures for operating the MONITOR setting function. For details of the setting function items, refer to descriptions of respective items.

1 Touch [SETUP] on the main source screen.

The SETUP selection screen is displayed.

2 Touch [MONITOR].

The MONITOR screen appears.

3 Touch [ ] or [ ] of the desired item to change its setting.

Setting items:

SLIDE / MONITOR O/C (OPEN/CLOSE)

4 Touch [RETURN] to return to the previous screen.

Touch [CONTROL] to return to the main source screen that was displayed before the setup operation was started.

Selecting the Monitor Position

The monitor can be set in 2 positions.

Setting item: SLIDE

Setting content: BACK / FRONT

BACK: Slides the display backwards.

FRONT: Slides the display forwards.

•If the monitor is forcibly pushed or pulled, you may not be able to set the monitor angle or position. In this case, press OPEN/CLOSE to close the monitor once, and then open the monitor again.

Setting Automatic Opening/Closing of the Monitor

Setting item: MONITOR O/C (OPEN / CLOSE)

Setting content: MANUAL / FULL / CLOSE

MANUAL: The monitor is manually opened or closed by pressing OPEN/CLOSE.

FULL: The monitor automatically opens and closes when the ignition key is turned to the “ACC” or “ON/OFF” position.

CLOSE: The monitor automatically closes when the ignition key is turned OFF.

Setup

DVD Setup

DVD Setup Operation

To display the DVD mode screen:

To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.

1Bring your vehicle to a complete stop at a safe location. Engage the parking brake.

2Keep pushing the foot brake and release the parking brake once then engage it again.

3When the parking brake is engaged for the second time, release the foot brake.

•For automatic transmission vehicles, place the transmission lever in the Park position.

Now, the locking system for the DVD mode operation has been released. Engaging the parking brake can reactivate the DVD mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of “To display the DVD mode screen.”

Each time the ignition is turned OFF, perform the procedure of “To display the DVD mode screen.”

The DVD Setup operation can be carried out after removing the disc from the unit or when playback of the disc has stopped.

The following steps 1 to 5 are common operations to each “Setting item” of DVD Setup. Refer to each section for details.

1 Touch [SETUP] on the main source screen.

The SETUP selection screen is displayed.

2 Touch [OTHER SETUP].

The OTHER SETUP screen appears.

3 Touch [ ] of DVD SETUP.

The DVD setup screen appears.

4 Touch [ ] or [ ], etc., of the desired item to change its setting.