Example of Bass Focus Setting
1After entering corrections for the front (left and right) speakers in STEP 15, the time difference is 1.5 ms for both
1.5ms1.5ms
∗
2After entering corrections for the left (front and rear) speakers in STEP 15, the time difference becomes 3.0 ms** for the front left speaker and 1.5 ms for the left rear speaker.
**Because the time difference was already set to 1.5 ms for the front left speaker in STEP 1, the additional correction in STEP 15 makes the time difference of the front left speaker 3.0 ms.
| 3.0ms |
1.5ms |
|
1.5ms | 1.5ms |
1.5ms
∗
Tips
*Subwoofer speaker
Delay (turn the rotary encoder) the audio signal to the front (left and right) speakers to make the apparent position of the subwoofer to be at the front. In doing this, the apparent position between the front (left and right) speakers and subwoofer will appear equal to the driver. After performing above, you can change the positions of left and right speakers by delaying the time.
Adjustment and Storing/Recalling of the Built-in Crossover
The High and Low Pass Filters on this unit can be adjusted to suit your personal taste.
Setting item:
1Touch [ ] of
The screen changes to the
2Adjust the crossover to your preference.
Displays the speaker to be adjusted When adjusting HPF: FRONT/REAR When adjusting LPF: SUBW.
Displays the selected HP or LP
Displays the
LPF
Variable range of selected
Active bar: displays the position of the
Switching between HPF and LPF
HPF/LPF changes each time [HPF/LPF] is touched.
HPF: Outputs all frequencies higher than that selected according to your preference.
LPF: Outputs all frequencies lower than that selected according to your preference.
(Only available when using the subwoofer output from this unit.)
•Except when the HPF and LPF is turned OFF, the subwoofer is in monaural mode.
Selecting the Cut-Off Frequency
Touch [ ] or [], then select the
Setting frequency: 80Hz, 120Hz, 160Hz
Adjusting the Slope
Touch [SLOPE], then adjust the HPF or LPF slope.
Setting slope: OFF,
Adjusting Cut-off Frequency Directly
Touching the variable range of the
3 Touch [RETURN] to return to the Previous screen.
Storing the Adjusted Contents
Following operation is performed after Step 3 above.
4Touch [MEMORY] on the BASS ENGINE screen.
5Within 5 seconds, touch any one of preset buttons [P.SET 1] through [P.SET 6].
The adjusted contents will be stored on the preset number you touch.
•The stored contents on the P.SET number remain undeleted despite a reset operation or disconnection of the battery power cord.
•Adjusted/set contents of each setting item in Bass Engine can be stored in the preset buttons (1 through 6).