
✔You will be asked to drive the route.
7Use the /
buttons on the rocker switch 7 to select START.
8Carry out the steps as instructed by the system.
Carrying out the system test
You have the option of carrying out a system test. The system checks the GPS antenna and whether the reversing signal and the vehicle ignition are correctly connected to the system.
1Select SYSTEM TEST menu item in the INSTALLATION setup menu.
2Press the OK button 8.
3Choose between SENSOR TEST, INTERNAL TEST and CALIBRAT. DATA.
✔The displays containing the corresponding test results are shown.
Activating / deactivating the code LED
You can activate the code LED to indicate that your TravelPilot is theft protec- ted. The code LED is located on the ON button 2. If
To activate / deactivate the code LED,
1select the
2keep pressing the OK button 8 until the required ON or OFF setting is displayed.
The code LED is activated / deactivated
ENGLISH
INSTALLATION |
SYSTEM TEST
CALIBRATION
GPS STATUS
SETTINGS |
INSTALL
CODE-LED ON
DEFAULT SET.
FM-SEEK SENS
KEYCARD
INTRODUCTION
NAVIGATION
RADIO MODE
CD MODE
CD CHANGER
SETUP
105
INDEX