
✔The master code input menu opens.
Enter the
4use the /
buttons on the rocker switch 7 to highlight the first digit of the master code and
5press the OK button 8.
✔The input cursor jumps one position to the right.
6Enter the remaining digits of the master code in the same way. If you entered a wrong digit by mistake,
7press the ESC button < or
7highlight the symbol and press the OK button 8. Once you have finished entering the whole master code,
8keep the OK button 8 pressed for longer than two seconds or
8highlight the symbol and press the OK button 8.
✔You will know that the new KeyCard has been accepted when the Travel- Pilot starts playing the audio source that was active last.
Factory default settings
The following table contains the factory default settings for the TravelPilot.
Setting | Default setting |
Display |
|
Day / night | On |
Viewing angle | 6 |
Brightness day | 7 |
Brightness night | 5 |
Special effects | 0 |
CODE |
0
0123456789 


ENGLISH
109
INTRODUCTION | NAVIGATION | RADIO MODE | CD MODE | CD CHANGER | SETUP | INDEX |