Blaupunkt RTM 127 Telephone operation, General information, PIN code, Reactivating the SIM card

Page 32

Telephone operation

General information

Using the Radiophone, you can make the same telephone calls as you can with a cel- lular phone.

Important:

You must be located in an area serviced by the GSM radio network and have the ac- cess privileges provided by a valid SIM card. This SIM card must be inserted into the unit (refer to the section on ”KeyCards and SIM cards” if necessary).

Emergency calls

The number to dial to place an emer- gency call in the GSM network any- where in the world is 112.

PIN code

(Personal Identification Number)

Normally, the SIM card will not operate the telephone until a personal identification number (PIN code) has been entered. This PIN code is included with the SIM card when you purchase it.

You can alter or even deactivate your PIN code. Refer to ”Programming with DSC – PIN CODE”.

Insert the SIM card/enter your PIN code

•Switch the unit on.

With the card tongue protruding, insert the trained SIM card into the slot with

If the PIN code is entered incorrectly three times in succession, it is necessary to use the PUK code (Personal Unblock code) to reactivate the card.

Reactivating the SIM card

The PUK code must be used to reactivate the SIM card.

The display shows “ENTER PUK”.

•Enter your code and press OK to con- firm.

•Enter a new PIN code.

IMPORTANT!

Be sure to make a note of the new PIN code!

You can place an emergency call by dial- ling this number even without inserting a SIM or KeyCard.

Please read the information in the section on ”Telephone operation – GSM emergen- cy calls”.

the contact surface facing up.	• Confirm your entry by pressing OK and
”ENTER PIN” will appear in the display.	repeat the entry.

•Enter the PIN code using the number keys, starting with the first digit.

•Press OK or #.

If the PIN code has been entered correctly, “CODE OK” will appear in the display fol- lowed by the menu which was used last.

If an incorrect PIN code has been entered, “WRONG PIN CODE” will appear in the dis- play followed by “ENTER PIN”.

98

Image 32

Contents Helsinki RTM PAC Contents Radio, CD changer optional Contents Radio, CD changer optional Contents Telephone Contents Telephone Safety standards Safety informationImportant information General informationInstallation Using the telephone in critical areasImportant information Emergency callsAccessories Starting up the Radiophone KeyCard and SIM cardBasic information Train KeyCard/SIM cards KeyCard and SIM cardRemove the KeyCard/SIM card Displaying the radio pass data DSC learn modeOptical warning of anti-theft protection On/off Volume Switch the unit on/off with the Key- CardSwitch the unit on/off via the ignition Operation in combination with an ignition timerTS / BND Alter the volumeSRC Source Selection buttons Radio mode Enter the frequency directly Store radio stationsAF / # MIX= Display Flashing card tongue? Rocker switch PlayedSelect operating mode Audio modeStation tuning Radio operation with RDS Radio Data SystemAF Alternative Frequency REG regional programManual tuning with Radio operation with RDS Radio Data SystemEnter the frequency directly Scroll through the broadcasting networks FM onlyAlter search sensitivity Switch from stereo to mono FM onlyRecall stored radio stations Switch traffic announcement priority on/off Traffic program station reception with RDS-EONRadiotext Beep toneSwitch CD changer operation on Switch off the warning beepCD changer operation optional Automatic search startCD changer operation optional Enter CD namesClear CD name ClearProgramming with DSC PaX PAC memoryProgramming with DSC Setup DSC menu SetupIgnition timer ResetUser mode KeyCard LEDOverview of the DSC default set- tings Setup TA volumeProgramming with DSC Radio DSC Menu RadioOverview of the DSC default settings Radio Save settings / end DSC programmingSensitivity Music/SpeechPage Telephone operation Telephone operation General informationPIN code Insert the SIM card/enter your PIN codeGSM emergency calls Telephone operationMake your first telephone call Quick telephone reference MIX Quick telephone referenceAF / # ? Rocker switch @ MEQuick telephone reference Using the telephone GSM network service areaUsing the telephone Dial a telephone numberCall waiting 2nd caller Answer/end a callRedial function Broker’s call/hold Conference callsInternational calls PaX PAC memoryMake telephone calls using the handset accessory Programming with DSCSelect the function SelectPhone book menu How to enter a name/textProgramming with DSC Phone book Find an entry by name Enter letters/charactersCapital and small letters Move the cursor in the input text boxFind an entry by position EntrySelect an entry by remote ControlAdd entry Access CapacityVolume Hands-free volumeHandset volume Show my phone numberAutomatic answer Automatic redialRinging tone My numberAOC parameters Advice of Charge Audible call timerExternal alarm PIN-codeOverview of the factory default Settings in the Setup menuTA Traffic Announcement During a telephone callProgramming with DSC Call Menu Call menuCall mailbox SMS messagesBroadcast Network selection ParametersSearch method Available networksCall meters Preferred networksCall forwarding Enter data for call forwardingPractical example of call forwarding Call barring Enter data for call barring Phone lockUser group Specifications AmplifierTelephone TunerGlossary Glossary Speed-dial User groupIndex Index Selecting a CD Selecting a track Bosch Gruppe