Troubleshooting Guide
The following check will assist in the correction of most problems which you may encounter with your unit.
Before going through the check list below, refer to the connection and operating procedures.
General
ProblemCause/Solution
No sound | ∙ Adjust the volume with the | button. |
∙Set the fader control to the centre position on the
Indications do not appear on the display window.
Remove the front panel and clean the connectors. See “Cleaning the Connectors” of “Maintenance” for details.
Tape playback
|
| Problem |
| Cause/Solution | |
|
|
|
|
| |
|
| Playback sound is distorted. |
| Contamination of the tape head. nClean the head. | |
|
|
|
|
| |
|
| The AMS does not operate |
| ∙ There is a noise in the space between tracks. | |
EN | |||||
| correctly. |
| ∙ A blank space is too short (less than four seconds). | ||
|
|
|
| ∙ + on the SEEK/AMS button is pressed immediately before | |
|
|
|
| the following tracks. | |
|
|
|
| ∙ = on the SEEK/AMS button is pressed immediately after | |
|
|
|
| the track starts. | |
|
|
|
| ∙ A long pause, or a passage of low frequencies or very low | |
|
|
|
| sound level is treated as a blank space. | |
|
|
|
|
| |
|
| Radio reception |
|
| |
|
|
|
|
| |
|
| Problem |
| Cause/Solution | |
|
|
|
|
| |
|
| Preset tuning is not possible. |
| ∙ Memorize the correct frequency. | |
|
|
|
| ∙ The broadcast is too weak. |
Automatic tuning is not possible.
The “ST” indication flashes.
The broadcast is too weak. nUse the manual tuning.
∙Tune in precisely.
∙The broadcast is too weak. nPress the SENS button to enter the MONO mode.
Disc play
Problem | Cause/Solution | |
Playback sound skips. | A dusty or defective disc. | |
|
|
|
28
Actual total number: | Sony |