INSTALLATION |
|
d.If the BCU/CAL has been purchased with the CAL software feature, the file CAL.DAT on Installation Diskette 4 must be modified. This modification should define each site interface to the System Manager for which the CAL feature is to provide service. If the unit is only licensed for the BCU feature, the file CAL.DAT may be left unmodified from that supplied with the release distribution.
e.Reboot the BCU/CAL.
INSTALLATION
1.Insert Installation Diskette 1 into the BCU/CAL floppy disk drive.
2.Apply unit power, and observe the user console. The remainder of the installation is provided by way of example. Actual observed output may be slightly different.
If the BCU/CAL hard disk drive has never been formatted (i.e., system integrator installation or the field unit's hard drive has been replaced) output similar to the following will be observed. If this message is displayed, the operator should answer “ yes <RET>” or simply “ <RET>” when prompted.
The hard disk drive could not be mounted.
Do you wish to perform a high level format [Y/N]? <RET>
Beginning high level format...
High level format successfully completed.
<OS> Beginning bootstrap loader: DATE: May 4, 1994 TIME: 1:46:36 pm
<OS> Floppy disk has been mounted.
<OS> Scanning floppy disk for LOADER.SX...
<OS> Copying LOADER.SX to the hard disk....*
<OS> Copy complete. 299029 bytes copied. <OS> Floppy disk has been unmounted. <OS> Scanning hard disk for LOADER.SX...
<OS> Loading file LOADER.SX from the hard disk... * <OS> Load complete. 97762 bytes loaded.
<OS> Hard disk has been unmounted.
<OS> Transferring program control to LOADER module...
<LOADER> Installing BCU/CAL: DATE: May 4, 1994 TIME: 1:48:00 pm
<LOADER> Floppy disk has been mounted.
Scanning floppy disk for BCU/CAL installation files...
<LOADER> Floppy disk has been unmounted.
<LOADER> USER ATTENTION REQUIRED.
Remove the current installation floppy diskette. Insert the next installation disk (if any). Strike <RETURN> to continue.
27