Sears 831.29776 user manual Symptom the Power does not Turn on, Position

Page 20

TROUBLE-SHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed.

If further assistance Is needed, call our toll-free HELPLINE at 1-800-736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).

1.SYMPTOM: THE POWER DOES NOT TURN ON

a.Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a propedy grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 9.) Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b.After the power cord has been plugged in, make sure that the key is fully inserted into the console. (See step 1 on page 11 .)

c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located at the front of the treadmill near the power cord. The switch must be in the =on" position.

c

Tripped

d

=On"_,

Position

2.SYMPTOM: THE POWER TURNS OFF DURING USE

a.Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in.

c.Remove the key from the console. Reinsert the key fully into the console. (See step I on page 11.)

d.Check to make sure that the on/off switch is in the "on" position. (See 1. d. above.)

e. If the treadmill still witl not run, please call our toll-freeHELPLINE.

3.SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON

a.Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b.If the walking belt still slows when walked on, please call our toll-free HELPLiNE.

4.SYMPTOM: AN ERROR CODE ("E2," "E3," "E4," OR "E5") APPEARS ON THE CONSOLE

a.Error code "E2" may appear in the SPEED display if the SPEED increase or START/PAUSE button is pressed and no movement of the walking belt is detected within seven seconds. Remove the key, wait for ten seconds, and then reinsert it. Make sure that you stand on the foot rails of the treadmill each time you start the walking belt. If the error code appears again, call our toll-free Customer Service Department. Do not operate the treadmill until the problem is corrected.

b.Error code "E3" may appear in the SPEED display if the speed of the walking belt surges above the se- lected speed setting. Remove the key, wait for ten seconds, and then reinsert it. If the error code appears

again, call our toll-free Customer Service Department. Do not operate the treadmill until the problem is cor-

20rected.

Image 20
Contents SEARS, Roebuck and CO., Hoffman ESTATES, IL PerformancetreadmillModel No Serial No Table of Contents Full 90 DAY WarrantyImportant Precautions Awarning Before YOU Begin Thank you for selecting the Proform = 725 TL treadWater Bottle Holder Foot Rails Front WheelOn page 19. Follow the instructions to lower the treadmill AssemblyRefer to HOW to Lower the Treadmill for USE Attach the Pulse Sensor 114 to the Head6and 114 I \ Make sure that the sensor window is pressed throughHOW to USE the Pulse Sensor Operation Adjustment HOW to Plug Power CordPerformant Lube TM Walking Belt Having an equipment-grounding conductor and aFeatures of the Console IagramoftheconsoleWeight HOW Touse EmanualmodeUAL Control AGE8. After a few Seconds, the heart Pulse dlsplay For this display to op Erate, the pulse senSor must be worn see Pulse Sensor on Mance WeHr aPressed, Time display =r,s j Ness Test McoeFIT Ness Test USE the PulseSpond while the Fitness Test program is selected HOW to Select the Information ModeCate your relative fit HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Remove the Cover Panel Latch.1 Closed Frame Cover Panel FastenerStorage Closed HOW to Move the TreadmillHOW to Lower the Treadmill for USE Symptom the Power does not Turn on Symptom the Power Turns OFF During USESymptom the Walking Belt Slows When Walked on PositionSymptom the Treadmill Sits Unevenly on the Floor Symptom the Pulse Sensor does not Function ProperlySymptom the Walking Belt is OFF-CENTER When Walked on Workout Guidelines Conditioning GuidelinesExercise Intensity Suggested Stretches Correct form for several basic stretches is shownPage Remove this Exploded Drawing and Part List from the Manual 131 \115 100 NSP FastenerSE /ARS Model No